Reconfigurability in an antenna system is a desired characteristic that has been the focus of much research in recent years. In this work, ohmic contact cantilever RF-MEMS switches are integrated with self-similar planar antennas to provide a reconfigurable antenna system that radiates similar patterns over a wide range of frequencies. The different issues encountered during the integration of the MEMS switches and the overall system design procedure are described herein. The final model radiates at three widely separated frequencies with very similar radiation patterns. The proposed concept can be extended to reconfigurable linear antenna arrays or to more complex antenna structures with large improvements in antenna performance.

The purpose of this letter is to introduce a compact ultrawideband (UWB) diversity antenna with a very low envelope correlation coefficient (ECC). The design employs a hybrid isolation enhancing and miniaturization technique. The antenna consists of two counter facing monopoles, and is miniaturized by using not only inverted-L stubs but also a complementary split-ring resonator (CSRR) on the ground plane. The added components enhance isolation and enable tighter packing of the antennas. The result is a very compact multiple-input-multiple-output (MIMO) array with an overall size of 23 × 29 mm ² , which covers the entire UWB spectrum from 3 to 12 GHz, with mutual coupling lower than -15 dB. Moreover, the CSRR unit that acts as a resonator is applied for the first time to suppress the interference of RF currents flowing through the ground plane of this UWB-MIMO/diversity antenna. The performance of the fabricated prototype in terms of scattering parameters, broadside (peak) gain, radiation patterns, efficiency, and ECC is presented and discussed.

Koch-shaped dipoles are introduced for the first time in a wideband antenna design and evolve the traditional Euclidean log-periodic dipole array into the log-periodic Koch-dipole array (LPKDA). Antenna size can be reduced while maintaining its overall performance characteristics. Observations and characteristics of both antennas are discussed. Advantages and disadvantages of the proposed LPKDA are validated through a fabricated proof-of-concept prototype that exhibited approximately 12% size reduction with minimal degradation in the impedance and pattern bandwidths. This is the first application of Koch prefractal elements in a miniaturized wideband antenna design.

This paper presents the design, fabrication and measurements of a direct-write printed low-cost and flexible inverted-F antenna on an ultra-low-cost paper-based organic substrate for wireless local area network (WLAN) and flexible display applications. Innovations include the study and utilization of paper as a high-frequency substrate for the first time in the gigahertz (GHz) range, the fabrication technology for the direct-write printing of the antenna as a flexible RF electronic device, and the investigation of antenna flexibility in conjunction with flexible displays. Although paper substrates exhibit relatively high dielectric losses (tanδ ~ 0.065 at 2.45 GHz), the maximum realized gain of the fabricated antenna is measured to be + 1.2 dBi giving a total efficiency ~ 82%. Simulated results of the antenna's return loss and radiation patterns agree well with the measurements, and can lead to a whole new class of flexible low-cost electronic devices of the future.

A phased-array test platform for studying the self-adapting capabilities of conformal antennas is developed and presented. Specifically, a four-port 2.45-GHz receiver with voltage controlled phase shifters and attenuators is designed along with four individual printed microstrip patch antennas attached to a conformal surface. Each antenna is connected to the corresponding receiver port with a flexible SMA cable. It is shown that with appropriate phase compensation, the distorted radiation pattern of the array can be recovered as the surface of the conformal array changes shape. This pattern recovery information is then used to develop a new self-adapting flexible 1 × 4 microstrip antenna array with an embedded flexible sensor system. In particular, a flexible resistive sensor is used to measure the deformation of the substrate of a conformal antenna array, while a sensor circuit is used to measure the changing resistance. The circuit then uses this information to control the individual voltage of the phase shifters of each radiating element in the array. It is shown that with appropriate phase compensation, the radiation properties of the array can be autonomously recovered as the surface of the flexible array changes shape during normal operation. Throughout this work, measurements are shown to agree with analytical solutions and simulations.

A wide-angle scanning planar phased array with magnetic current elements is proposed. A pattern reconfigurable technique is used to design the element that enhances scanning gain and decreases the sidelobe level throughout the entire scanning range. The array is comprised of eight elements in a 2×4 arrangement with uniform spacing. The proposed phased array operates at 5.8 GHz and can scan with 3 dB beamwidth the entire upper ground elevation plane from -90° to +90° enabled by a two-step pattern reconfigurability mechanism consisting of: 1) coarse-angle scanning and 2) line-angle scanning. Significant outcomes also include the reduced sidelobe level (less than 7.8 dB) and the particularly small fluctuation (±0.75 dB) of the gain during scanning over a scanning range of 150° (from 75° to +75° in the elevation plane). With the absence of any structure above the ground level, the high efficiency, and the coverage of the entire upper half-space, this proposed antenna array is very attractive for a variety of phased array applications, particularly those that require a Hush-mounted structure.