To enhance the corrosion resistance of underground pipelines made of low carbon steel, nano-TiO₂-modified polyurea was applied to their surface. The anti-corrosion performance of these nano-TiO₂-modified coatings was tested by immersing them in a NACE (5 wt.% NaCl + 0.5 wt.% CH3COOH) solution under high temperatures and high CO₂ pressures. The mass variation, SEM morphology, and open-circuit potential were determined. EIS tests, neutral salt spray tests, and contact angle measurements were carried out to analyze the effect of nanoparticles on corrosion resistance. Within the same pressure range, the polyurea coating shows the highest corrosion resistance when 5% TiO₂ nanoparticles were added compared to that of polyurea coatings with 0%, 10%, and 15% TiO₂ added. Coatings with 5% TiO₂ nanoparticles showed rapid diffusion after being immersed for 96 h, indicating that the anti-corrosion performance of the coating weakened.

To improve the service life of continuous casting crystallizer, the NiCo-ZrB₂ coating was prepared using nanocomposite plating technology. Uniformly dispersed nano-ZrB₂ particles significantly enhanced the hardness and wear resistance of the coating. Upon testing, the hardness of the coating exceeded 700 HV, with a friction coefficient below 0.2, which was superior to those of pure NiCo or other nanocomposite NiCo coatings reported previously. Microscopic analysis revealed that the addition of dispersants and ultrasonic vibration treatment had facilitated the homogeneous distribution of nano-ZrB₂ within the matrix, thereby promoting the formation of numerous nano-twins. Due to dispersion strengthening, fine grain strengthening, and twinning strengthening, the wear behavior of the coating changed from fatigue wear to abrasive wear, and the wear volume was significantly reduced by 82%. The above findings could potentially extend the service life of the coating, reduce the cost of steel loss per ton, and have broad application prospects in other surface protection fields.