Polyethylene (PE) pipe, particularly high-density polyethylene (HDPE) pipe, has been successfully utilized to transport cooling water for both non-safety- and safety-related applications in nuclear power plant (NPP). Though ASME Code Case N755, which is the first code case related to NPP HDPE pipe, requires a thorough nondestructive examination (NDE) of HDPE joints. However, no executable regulations presently exist because of the lack of a feasible NDE technique for HDPE pipe in NPP. This work presents a review of current developments in NDE technology for both HDPE pipe in NPP with a diameter of less than 400 mm and that of a larger size. For the former category, phased array ultrasonic technique is proven effective for inspecting typical defects in HDPE pipe, and is thus used in Chinese national standards GB/T 29460 and GB/T 29461. A defect-recognition technique is developed based on pattern recognition, and a safety assessment principle is summarized from the database of destructive testing. On the other hand, recent research and practical studies reveal that in current ultrasonic-inspection technology, the absence of effective ultrasonic inspection for large size was lack of consideration of the viscoelasticity effect of PE on acoustic wave propagation in current ultrasonic inspection technology. Furthermore, main technical problems were analyzed in the paper to achieve an effective ultrasonic test method in accordance to the safety and efficiency requirements of related regulations and standards. Finally, the development trend and challenges of NDE test technology for HDPE in NPP are discussed.
14 February 2014 in Journal of Pressure Vessel Technology
Polyethylene (PE) pipes are widely used in natural gas transportation systems in urban areas nowadays. As landslide caused by earthquake would cause destructive damage to buried pipes, increasing attention is attracted to the safety of buried PE pipes under seismic load. In this paper, the deformation behavior of PE pipe subjected to seismic landslide was investigated and a related failure criterion due to yielding was proposed. Based on extensive uniaxial tensile tests, a rate-dependent constitutive model of PE was applied to simulate the mechanical behavior of PE pipes. The extended Drucker-Prager model was used for surrounding soil. In our proposed finite element model, a quartic polynomial bending deflection displacement normal to the pipeline was loaded along the axial direction of PE pipe. The numerical simulation results revealed that the main failure mode of buried PE pipe subjected to seismic landslide shifted from bending deformation to ovalization deformation with increasing bending deflection. On the basis of deformation behavior analysis, failure criterion curves were put forward, which depicts the maximum relative deflection of the pipe cross-section, and the maximum displacement of the pipe versus pipe length subjected to seismic landslide. The results may be referable for design and safety assessment of PE pipes due to seismic landslide.
29 November 2011 in Journal of Applied Polymer Science
This technical brief proposes a defect recognition model to recognize four typical defects of phased array ultrasonic testing (PA-UT) images for electrofusion (EF) joints. PA-UT has been proved to be the most feasible way to inspect defects in EF joints of polyethylene pipes. The recognition of defects in PA-UT images relies on the experience of operators, resulting in inconsistent defective detection rate and low recognition speed. The proposed recognition model was composed of an anomaly detection model and a defect detection model. The anomaly detection model recognized anomalies in PA-UT images, meeting the requirement of real-time recognition for practical inspection. The defect detection model classified and located defects in abnormal PA-UT images, achieving high accuracy of defects recognition. By comparing detection models, optimizing parameters and augmenting dataset, the anomaly detection model and defect detection model reached a good combination of accuracy and speed.