To improve the machining accuracy of thin-walled curved surface parts, this paper proposes a machining error compensation method based on on-machine measurement (OMM) and Non-Uniform Rational B-Spline (NURBS) surface reconstruction. This method first employs a high-precision contact probe for on-machine measurement after semi-finishing the part, acquiring discrete point cloud data of the actual machined surface. The NURBS surface control points are fitted based on the measured data to reconstruct the machined surface. The machining error of the surface is obtained by calculating the distance between the machined surface and the design surface. A compensation surface and compensated machining toolpath are then generated based on a mirror compensation model. Finally, the machining errors before and after compensation for thin-walled curved surface parts were experimentally validated. Using this compensation method, the maximum value of the machining error was reduced from 0.2062mm to 0.1008mm, and the average absolute value of the machining error was reduced from 0.0610mm to 0.0191mm, while machining accuracy improved by 68.65%. It was verified that this method could effectively reduce machining errors. This method can be used to detect and compensate for machining errors in thin-walled curved surface parts, providing an effective technical solution for machining high-precision thin-walled curved surface parts.
30 May 2018 in International Journal of Materials Research
Experiments for ultrasonic-assisted pulsed-laser surface irradiation and pulsed-laser surface irradiation were conducted based on an Nd:YAG pulsed-laser machine in order to study the effects produced by ultrasonic vibration on the AISI 1045 steel surface. In addition, the effects of the ultrasonic vibration on the AISI 1045 steel surface are discussed. The results show that larger tensile residual stress is induced at the pulsed-laser surface irradiation area, and the resultant surface 3D morphology is a noticeable sink mark owing to the temperature effect and the tensile residual stress effect. The surface integrity of AISI 1045 steel subjected to pulsed-laser surface irradiation can be improved with the aid of the extra acoustic field. The findings confirm that the acoustic field can be introduced to high-power laser processing technology to improve the surface integrity of the treated materials.
This study aims to investigate the coating properties of Stellite 21 powder laser-clad on 304 stainless steel substrates with different laser parameters, but under the same specific energy. The surface hardness of the coating was analyzed using a Vickers hardness tester and a nanoindenter instrument, while the microstructure and wear mechanisms were investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive spectroscopy (EDS). Under the same laser energy density conditions, the 1260 W-540 mm/min process (S3) produced a fine equiaxed structure containing dispersed chromium-rich carbides. The coating surface achieved a maximum average microhardness of 420.51 HV0.3, but its wear resistance was the worst, with a wear rate of 7.4 × 10−2 μm3·N−1·μm−1. By comparison, the 1400 W-600 mm/min sample (S2) formed a relatively stable carbide network structure, exhibited the smallest fluctuation in friction coefficient, and had a lower wear rate of 5.2 × 10−2 μm3·N−1·μm−1. The results indicate that identical laser energy density does not guarantee the same coating performance; the matching of power and scanning speed can significantly alter the thermal history and microstructural characteristics of the melt pool.