The paper presents results of a study on T-shaped composite concrete beams with a variously located interface. Damage to tested beams was caused by shear. The crack patterns and the value of the force causing interface cracking were analysed. Conclusions concerning the failure mechanism were formulated. Moreover, the influence of the interface location and of the difference between the moduli of elasticity of joint materials on stress in the interface was also analysed.

This project’s objective was to create a circular economy in the composites sector by examining the possibility of using wind turbine blade composite materials to construct noise-absorbing barriers for roads. The possibility of constructing road noise barrier panels from components obtained from turbine blades was conceptually examined, and the geometry and construction of wind turbine blades were evaluated for their suitability as filler components for panels. The tensile strength parameters of two types of composites made from windmill blades—a solid composite and a sandwich type—were established based on material tests. The strength of the composite elements cut from a windmill propeller was analyzed, and a three-dimensional numerical model was created using the finite element method. The strength values of the composite used to construct the noise barriers were compared with the stresses resulting from loads operating on the road noise barriers, as determined in compliance with current standards. It was discovered that acoustic screens composed of composite materials derived from wind turbine blades may withstand loads associated with wind pressure and vehicle traffic with sufficient resistance. In order to evaluate the environmental benefits resulting from the use of composite material made from wind turbine blades to make noise barriers, this study presents the values of the embodied energy and embodied carbon for several types of road noise barriers using life cycle assessment.

The study presented constitutes the next step of authors’ investigations on the concrete composite T-shaped beams. The comparison of the failure modes and crack patterns of numerical models and beams tested was performed previously. In this paper, analyses concentrate on determination the proper values of cohesive surface parameters ensuring the high conformity of deformation and strains of the numerical model to the experimental results. In the particular series of beams the interfaces between concrete parts are varied as follows: reinforced joint with normal and tangential interactions only (BZ/S2/A), non-reinforced joint with adhesion (BZ/P), and reinforced joint with adhesion (BZ/P+S). Material properties used in numerical model are based on obtained in the laboratory ones. Furthermore, the ‘traction–separation’ law in the ABAQUS software defining the cohesion surface is used and analysis of the cohesive parameters response to interface roughness is carried out. The results show a strong dependence between the cohesion surface parameters and the response of the composite beam. A very good convergence of the numerical model with the experimental results in terms of ‘force-displacement’ relationship is achieved. Finally the parameters defined in the ABAQUS are determined, which have a key impact on the beams response.