Laser powder bed fusion (LPBF) is an additive manufacturing process that has gained interest for its material fabrication due to multiple advantages, such as the ability to print parts with small feature sizes, good mechanical properties, reduced material waste, etc. However, variations in the key process parameters in LPBF may result in the instantiation of porosity defects and variation in build rate. Particularly, volumetric energy density (VED) is a variable that encapsulates a number of those parameters and represents the amount of energy input from the laser source to the feedstock. VED has been traditionally used to inform the quality of the printed part but different values of VED are presented as optimal values for certain material systems. An optimal VED value can be maintained by changing the key process parameters so that various combinations yield a constant value. In this study, an optimal constant VED value is maintained while printing SS316L with variable key processing parameters. Porosity analysis is performed using optical microscopy, as well as X-ray computed tomography, to reveal the volume density and distribution of those pores. Two primary defect categories are identified, namely lack of fusion and porosity induced by balling defects. The findings indicate that, even at optimal VED, variations in process parameters can significantly influence defect type, underscoring the sensitivity of defect formation to the variation of these parameters. Furthermore, a minor change in the build rate, driven by adjustments in process parameters, was found to influence defect categories. These findings emphasize that fine tuning the process parameters and build rate is essential to minimize defects. Finally, fiducial marks have been identified as a source of unintentional porosity defects. These results enable the refinement of process parameters, ultimately optimizing LPBF to achieve enhanced material density and expedite the printing.
The ongoing advancement of additive manufacturing (AM) techniques, particularly in laser powder bed fusion (LPBF), is effectively bridging the knowledge gap between AM and conventional manufacturing methods. At present, most of the research is focused on optimizing key process parameters such as laser power, laser speed, hatch spacing, layer thickness, scan pattern, powder size distribution, and so on. These studies help improve the part density and refine the microstructure of LPBF components, thereby enhancing the mechanical properties. Despite these advancements, an area in LPBF that is receiving comparatively less attention is the shielding gas: its flow during the printing process, and its relationships to the underlying structures and properties of AM materials. Shielding gas plays an important role during the printing process by creating an inert medium so the printed parts do not react with the atmosphere while also facilitating the removal of any process by-products that develop during the printing. Within the scientific community, there is an absence of review articles that summarize current research on shielding gas flow. This work addresses this gap by reviewing the current literature on different shielding gases used, how the printer gas inlet design configurations help in the uniform flow of the gas, the role of the gas in the elimination of by-products, and their influence on the melt pool, part quality, and repeatability. All aspects discussed in this review article are crucial to the advancement of metal AM processes that require the use of a shielding gas, specifically LPBF, and the qualification of materials produced for a variety of industrial applications.