The stress of surrounding rock and supporting structure is very complicated during the construction of a loose rock tunnel. The characteristics analysis of collapse arch is very important for the construction safety. This paper compares and analyzes the applicability of the full section method and the three-step method under shallow buried loose surrounding rock, reveals the influence law of tunnel excavation height span ratio on the stability of a pseudo-collapse arch of surrounding rock under shallow buried loose surrounding rock, and rationally chooses the three-step method as the dominant construction method of tunnel construction under this geological condition. For the three-step construction method, the optimization study of the excavation height of the upper step is carried out, the relationship between the excavation height of the tunnel and the stress concentration area under the condition of shallow buried loose surrounding rock is revealed, the influence of surrounding rock stress release on the stability of the tunnel surrounding rock is explored, and the damage of tunnel rock mass caused by the stress concentration phenomenon is analyzed. It is determined that the optimal excavation height of the upper step is 0.4H under the geological conditions of the DS project in Sichuan province, China, under construction. This paper analyzes the influence of structural plane spacing on the stability of a tunnel collapse arch under shallow buried loose conditions and reveals the law that the smaller the structural plane spacing, the worse the self-bearing capacity of the collapse arch, and the higher the risk of engineering accidents such as rock collapse or even collapse in the tunnel, which effectively guides the safe construction of the tunnel under shallow buried loose geological conditions.

In this research, the rockbolt mechanism of a jointed rock mass under uniaxial tension was systematically revealed with a laboratory test and a numerical simulation. It was found that the rockbolt rock mass experienced five stages under uniaxial tension, the densification stage, elastic stage, plastic deformation stage, progressive debonding stage, and complete debonding stage. The stress-strain curve and ultimate tensile strength of a rockbolt rock mass were analyzed by taking the rockbolt spacing and rockbolt angle as variables. It was found that the improvement effect of the reduction of the rockbolt spacing on the ultimate tensile strength was limited. When the rockbolt spacing was reduced to a certain limit, the stress concentration area between adjacent rockbolts was connected and destroyed, resulting in the increase of the rockbolt rock strength becoming smaller, and even having a downward trend. The increase of the rockbolt angle led to the change of the stress mode and failure mode of the whole structure, and the ultimate tensile strength first increased and then decreased. The optimal rockbolt angle was between 60° and 70°. It is worth noting that there was an obvious mechanical occlusion between the thread on the rockbolt surface and the rock mass, resulting in the multi-stage step-down characteristic of the stress-strain curve in the complete debonding stage. The results of this study can provide a reference for the design and construction of similar projects.