(1) This work answers the question of whether and to what extent there is a significant difference in mechanical properties when different additive manufacturing processes are applied to the material 1.2709. The Laser-Powder-Bed-Fusion (L-PBF) and Laser-Metal-Deposition (LMD) processes are considered, as they differ fundamentally in the way a part is manufactured. (2) Known process parameters for low-porosity parts were used to fabricate tensile strength specimens. Half of the specimens were heat-treated, and all specimens were tested for mechanical properties in a quasi-static tensile test. In addition, the material hardness was determined. (3) It was found that, firstly, heat treatment resulted in a sharp increase in mechanical properties such as hardness, elastic modulus, yield strength and ultimate strength. In addition to the increase in these properties, the elongation at break also decreases significantly after heat treatment. The choice of process, on the other hand, does not give either process a clear advantage in terms of mechanical properties but shows that it is necessary to consider the essential mechanical properties for a desired application.
Additive manufacturing of metallic components often results in the formation of columnar grain structures aligned along the build direction. These elongated grains can introduce anisotropy, negatively impacting the mechanical properties of the components. This study aimed to achieve controlled solidification with a fine-grained microstructure to enhance the mechanical performance of printed parts. Stainless steel 316L was used as the test material. High-intensity ultrasound was applied during the direct energy deposition (DED) process to inhibit the formation of columnar grains. The investigation emphasized the importance of amplitude changes of the ultrasound wave as the system’s geometry continuously evolves with the addition of multiple layers and assessed how these changes influence the grain size and distribution. Initial tests revealed significant amplitude fluctuations during layer deposition, highlighting the impact of layer deposition on process uniformity. The mechanical results demonstrated that the application of ultrasound effectively refined the grain structure, leading to a 15% increase in tensile strength compared to conventionally additively manufactured samples.