The electromagnetic fields surrounding high-power wireless power transfer (WPT) systems in electric vehicles (EVs) may threaten the electromagnetic safety (EMS) of pedestrians nearby. This paper first evaluates the dosimetry for a 10 kW WPT system for EVs. A total of three human models and a full-size EV model are constructed and used. Numerical computation with the finite element method is implemented for three exposure scenarios of the adult models, including an unexplored and severe one. A child model lying in the same position as the adult model is also evaluated. To satisfy the EMS requirement, the maximum allowable power (MAP) of the WPT system is merely 1.0 kW. Then, three feasible measures are proposed to protect people from the electromagnetic hazards of WPT systems. 1) A safety distance for pedestrians during the normal charging of the system is established. 2) A detailed power control strategy is presented on the basis of the findings regarding the distribution characteristics of the near-field magnetic field of the WPT system. 3) A novel method of detecting the offset distance of a WPT system is proposed, and a small experimental WPT system coupler is developed to verify the method. These measures can effectively alleviate the conflict between the MAP of the system and EMS requirements for people.
12 December 2019 in IEEE Transactions on Industrial Electronics
Spatial energy distribution characteristics (EDCs) as well as power and efficiency should be considered to ensure electromagnetic safety of people nearby when analyzing some magnetically coupled resonant (MCR) wireless power transfer (WPT) systems, which is difficult for circuit theory. This paper first proposes energy-concentrating effect (ECE) of unit transmitting active power (TAP) based on the EDCs of the system with SS/PS compensation. And we find that the area integral of the active power density on the infinite plane perpendicular to the transmission direction between the coils equals the TAP of the system, which is consistent with the result obtained by circuit theory. Several couplers are designed and optimized based on the ECE. Simulation and experimental results reveal that the optimized inner-outer ring (IOR) and disc-coil couplers increase the ECE by 10% and 32%, respectively, compared with the original spiral-coil coupler. Furthermore, the electromagnetic exposure of the human body in the same position around the three couplers indicates that the maximum induced electric field and specific absorption rate in the human body around the optimized IOR and disc-coil couplers are substantially decreased, and thus the two couplers increase the maximum allowable TAP of the system from 297W to 379W and 700W.
With the extensive applications of magnetically coupled resonant wireless power transfer (WPT), improving the power transfer efficiency (PTE) of WPT systems is critical. Magnetic metamaterials (MTMs) can effectively improve the PTE. However, currently the design of MTMs is mainly based on microwave or optical theory, and their applicability in low-frequency WPT systems needs to be further explored. In this paper, a fast and effective method for the design and optimization of low-frequency MTM is provided. Firstly, based on circuit theory and mutual inductance calculation, the PTE of WPT systems is concluded in an equation that concerns the position of a 2-D MTM slab and added compensation capacitance of MTM unit coils. Two WPT systems with large differences in coil size of the transmitter (Tx) and receiver (Rx) or the same size are considered, and a directly separating variables method is proposed to optimize the MTM slab position and the compensation capacitance of unit coils to maximize PTE when the MTM slab position changes axially between Tx and Rx. It is found that the optimal MTM slab positions for the two systems are remarkably different, and the PTE impressively presents a capacitance splitting phenomenon with the change of compensation capacitance. Finally, two MTM-enhanced WPT systems are established to verify the theoretical calculation. The experiments show that the maximum PTE is significantly increased by 144% and 31% respectively by adopting optimized compensation capacitance compared with that without MTM for the two systems with different or same transceiver coil size.
A novel, general structure of tunable frequency-selective surface that does not require additional bias networks is presented. Varactor diodes are positioned in the middle of each cell, and no via is required. Inductors between the cells provide DC connections, which also choke high frequency signal. Two FSS patterns are applied in the tunable structure. Simulation results of the two FSS patterns both show that by altering the capacitance of the varactors from 0.3 to 3.0 pF, a wide frequency tunability can be achieved, and at the same time the bandwidth becomes obviously wider.
8 August 2018 in IEEE Transactions on Electromagnetic Compatibility
Magnetic field (MF) analysis in wireless power transfer systems (WPTSs) is one of the key problems. This paper proposes an optimization algorithm to determine the MF by calculating the simplified Biot–Savart integral. The number of intervals (NOIs) in the integral is the key to the accuracy and efficiency of the algorithm. The maximum of the MF changes sharply with NOI, leading to a bad optimal NOI. To solve this problem, two methods are used. First, according to the positions of the maximum, the relatively high value, and the idea of noise-point-elimination in digital image processing, the maximum value filtered method (MVFM) is proposed. The second method is the two-dimensional (2-D) feature selective validation (FSV). By combining the MVFM and the 2D-FSV, on an NOI step equaling to 10, the optimal NOI is decreased from 350 to 90, which significantly meets the balance of the accuracy and efficiency. Furthermore, for a variable NOI step situation, local and global optimal NOIs have been analyzed. MVFM is not only suitable for the MF calculation in WPTSs but also for when the maximum value needs to be addressed. 2D-FSV also expands the application from the final result evaluation to the evaluation in an algorithm.
16 July 2019 in IEEE Transactions on Antennas and Propagation
Magnetic fields are crucial for wireless power transfer systems (WPTSs) via magnetic coupling. This paper analyzes the polarization characteristic of the magnetic field in WPTS. First, a typical WPTS and its magnetic field are modeled. The magnitude and phase distributions of the magnetic field components are calculated and discussed. By adopting polarization theory, the magnetic field in WPT is analyzed via the polarization characteristic. A unique characteristic is found. Unlike far-field polarization, the characteristic possesses the following points: First, the linear, circular, and elliptical polarization states simultaneously exist in the WPT. Second, linear polarization is the intrinsic polarization state and forms a 3D ellipsoid; circular polarization forms two rings around with the WPTS and changes with the currents. The analysis has also been proved by simulations and experiments.