Here, we examined multitemporal behavior of fully polarimetric SAR (PolSAR) parameters at L-band in relation to the stem volume of boreal forests. The PolSAR parameters were evaluated in terms of their temporal consistency, inter-dependence and suitability for forest stem volume estimation across several seasonal conditions (frozen, thaw and unfrozen). The satellite SAR data were represented by a time series of PolSAR images acquired during several seasons in the years 2006 to 2009 by the ALOS PALSAR sensor. The study area was in central Finland, and represented a managed area in typical boreal mixed forest land. Utility of different PolSAR parameters, their temporal stability and cross-correlations were studied along with reference stand-level stem volume data from forest inventory. Further, two polarimetric parameters, cross-polarization backscatter and co-polarization coherence, were chosen for further investigation and stem volume retrieval. A relationship between forest stem volume and PolSAR parameters was established using the kNN regression approach. Ways of optimally combining PolSAR images were evaluated as well. For a single scene, best results were observed with polarimetric coherence (RMSE ≈ 38.8 m³/ha) for scene acquired in frozen conditions. An RMSE of 40.8 m³/ha (42.9%, R² = 0.66) was achieved for cross-polarization backscatter in the best case. Cross-polarization backscatter was a better predictor than polarimetric coherence for few summer scenes. Multitemporal aggregation of selected PolSAR scenes improved estimates for both studied PolSAR parameters. Stronger improvement was observed for coherence with RMSE down to 34 m³/ha (35.8%, R² = 0.77) compared to 38.8–51.6 m³/ha (40.8–54.3%) from separate scenes. Finally, the accuracy statistics reached RMSE of 32.2 m³/ha (34%, R² = 0.79) when multitemporal HHVV coherence was combined with multitemporal HV-backscatter.

The applicability of optical and synthetic aperture radar (SAR) data for land cover classification to support REDD+ (Reducing Emissions from Deforestation and Forest Degradation) MRV (measuring, reporting and verification) services was tested on a tropical to sub-tropical test site. The 100 km by 100 km test site was situated in the State of Chiapas in Mexico. Land cover classifications were computed using RapidEye and Landsat TM optical satellite images and ALOS PALSAR L-band and Envisat ASAR C-band images. Identical sample plot data from Kompsat-2 imagery of one-metre spatial resolution were used for the accuracy assessment. The overall accuracy for forest and non-forest classification varied between 95% for the RapidEye classification and 74% for the Envisat ASAR classification. For more detailed land cover classification, the accuracies varied between 89% and 70%, respectively. A combination of Landsat TM and ALOS PALSAR data sets provided only 1% improvement in the overall accuracy. The biases were small in most classifications, varying from practically zero for the Landsat TM based classification to a 7% overestimation of forest area in the Envisat ASAR classification. Considering the pros and cons of the data types, we recommend optical data of 10 m spatial resolution as the primary data source for REDD MRV purposes. The results with L-band SAR data were nearly as accurate as the optical data but considering the present maturity of the imaging systems and image analysis methods, the L-band SAR is recommended as a secondary data source. The C-band SAR clearly has poorer potential than the L-band but it is applicable in stratification for a statistical sampling when other image types are unavailable.

In land monitoring applications, clouds and shadows are considered noise that should be removed as automatically and quickly as possible, before further analysis. This paper presents a method to detect clouds and shadows in Suomi NPP satellite’s VIIRS (Visible Infrared Imaging Radiometer Suite) satellite images. The proposed cloud and shadow detection method has two distinct features when compared to many other methods. First, the method does not use the thermal bands and can thus be applied to other sensors which do not contain thermal channels, such as Sentinel-2 data. Secondly, the method uses the ratio between blue and green reflectance to detect shadows. Seven hundred and forty-seven VIIRS images over Fennoscandia from August 2014 to April 2016 were processed to train and develop the method. Twenty four points from every tenth of the images were used in accuracy assessment. These 1752 points were interpreted visually to cloud, cloud shadow and clear classes, then compared to the output of the cloud and shadow detection. The comparison on VIIRS images showed 94.2% correct detection rates and 11.1% false alarms for clouds, and respectively 36.1% and 82.7% for shadows. The results on cloud detection were similar to state-of-the-art methods. Shadows showed correctly on the northern edge of the clouds, but many shadows were wrongly assigned to other classes in some cases (e.g., to water class on lake and forest boundary, or with shadows over cloud). This may be due to the low spatial resolution of VIIRS images, where shadows are only a few pixels wide and contain lots of mixed pixels.

Dense time series of stripmap RADARSAT-2 data acquired in the Multilook Fine mode were used for detecting and mapping the extent of selective logging operations in the tropical forest area in the northern part of the Republic of the Congo. Due to limited radiometric sensitivity to forest biomass variation at C-band, basic multitemporal change detection approach was supplemented by spatial texture analysis to separate disturbed forest from intact. The developed technique primarily uses multi-temporal aggregation of orthorectified synthetic aperture radar (SAR) imagery that are acquired before and after the logging operations. The actual change analysis is based on textural features of the log-ratio image calculated using two SAR temporal composites compiled of SAR scenes acquired before and after the logging operations. Multitemporal aggregation and filtering of SAR scenes decreased speckle and made the extracted textural features more prominent. The overall detection accuracy was around 80%, with some underestimation of the area of forest disturbance compared to reference based on optical data. The user’s accuracy for disturbed forest varied from 76.7% to 94.9% depending on the accuracy assessment approach. We conclude that change detection utilizing RADARSAT-2 time series represents a useful instrument to locate areas of selective logging in tropical forests.

In this study, we assess the potential of long time series of Sentinel-1 SAR data to predict forest growing stock volume and evaluate the temporal dynamics of the predictions. The boreal coniferous forests study site is located near the Hyytiälä forest station in central Finland and covers an area of 2,500 km ² with nearly 17,000 stands. We considered several prediction approaches (linear, support vector and random forests regression) and fine-tuned them to predict growing stock volume in several evaluation scenarios. The analyses used 96 Sentinel-1 images acquired over three years. Different approaches for aggregating SAR images and choosing feature (predictor) variables were evaluated. Our results demonstrate considerable decrease in RMSEs of growing stock volume as the number of images increases. While prediction accuracy using individual Sentinel-1 images varied from 85 to 91 m ³ /ha RMSE (relative RMSE 50-53%), RMSE with combined images decreased to 75.6 m ³ /ha (relative RMSE 44%). Feature extraction and dimension reduction techniques facilitated achieving the near-optimal prediction accuracy using only 8-10 images. When using assemblages of eight consecutive images, the GSV was predicted with the greatest accuracy when initial acquisitions started between September and January. Highlights: Time series of 96 Sentinel-1 images is analysed over study area with 17,762 forest stands. Rigorous evaluation of tools for SAR feature selection and GSV prediction. Improved periodic seasonality using assemblages of consecutive Sentinel-1 images. Analysis of combining images acquired in “frozen” and “dry summer” conditions. Competitive estimates using calculation of prediction errors with stand-area weighting.