It is useful to carefully observe the evolution of foam structures to elucidate the factors affecting cream during whipping. In this study, confocal laser scanning microscopy and a double dyeing technology were used to investigate the microstructural evolution of a rigid foam structure in whipped cream. The location of fat and proteins were determined according to the signals they produce at different characteristic wavelengths. Protein membranes on the surface of air bubbles were clearly observed. A simple yet comprehensive characterization of the whipping process was established according to the micrographs and supported by relevant theories. The formation of a rigid foam structure depends on foaming of the protein in the plasma phase and partial coalescence of fat globules. The formation of protein foam in the cream, creation of net structure, and system breakage and collapse phenomena occurring throughout the whole whipping evolution process was depicted and distinguished visually by different colors.

The aim of this work was to evaluate the effects of nanofiltration and evaporation concentration technologies on the physiochemical properties of milk protein concentrate (MPC) during processing. Skim milk, ultrafiltered milk, evaporated milk, nanofiltered milk, evaporated MPC, and nanofiltered MPC samples were collected at different processing stages. Chemical composition, microstructure of casein micelles, free sulfhydryl content, and surface hydrophobicity of the samples were determined. The insolubility index of MPC was also determined. Casein micelles aggregated compactly after evaporation while surface hydrophobicity increased and free sulfhydryl content decreased in evaporated milk compared with skim milk. However, the microstructure of the casein micelles was relatively undisturbed after nanofiltration, with reduced surface hydrophobicity and free sulfhydryl content. No significant difference was found in chemical composition between the 2 MPC preparations: approximately 61.40% protein and 28.49% lactose. In addition, the particulate microstructures of both MPC were similar. However, the insolubility index of evaporated MPC was significantly (0.58mL) higher than that of nanofiltered MPC. Nanofiltration may be an effective way to improve the solubility of MPC products.

This study investigated the impact of different preheat treatments on the emulsifying and gel textural properties of soy protein with varying 11S/7S ratios. A mixture of 7S and 11S globulins, obtained from defatted soybean meal, was prepared at different ratios. The mixed proteins were subjected to preheating (75 °C, 85 °C, and 95 °C for 5 min) or non-preheating, followed by spray drying or non-spray drying. The solubility of protein mixtures rich in the 7S fraction tended to decrease significantly after heating at 85 °C, while protein mixtures rich in the 11S fraction showed a significant decrease after heating at 95 °C. Surprisingly, the emulsion stability index (ESI) of protein mixtures rich in the 7S fraction significantly improved twofold during processing at 75 °C. This study revealed a negative correlation between the emulsifying ability of soy protein and the 11S/7S ratio. For protein mixtures rich in either the 7S or the 11S fractions, gelling proprieties as well as emulsion activity index (EAI) and ESI showed no significant changes after spray drying; however, surface hydrophobicity was significantly enhanced following heating at 85 °C post-spray drying treatment. These findings provide insights into the alterations in gelling and emulsifying properties during various heating processes, offering great potential for producing soy protein ingredients with enhanced emulsifying ability and gelling property. They also contribute to establishing a theoretical basis for the standardized production of soy protein isolate with specific functional characteristics.