In this paper a comparative study between numerical and experimental results from particle image velocimetry (PIV) measurements is presented in the case of two-dimensional electrohydrodynamic plumes that arise when a sharp metallic blade, submerged in non-conducting liquids, supports a high electric potential. Experiments and numerical simulations have been conducted in order to compare both the approaches. Very good agreement has been found through velocity profiles and velocity fields which proves the relevance of our numerical model. For high potentials the jet flow issued forth from the blade becomes unsteady and starts to flap on the vertical wall. Some snapshots of the temporal evolution of the isocontours of charge density which is not accessible from experiment are presented thanks to the numerical simulation.
HFE-7000 and HFE-7100 have shown a promising importance in the Electrohydrodynamics (EHD) domain. Their dielectric properties are investigated in a temperature range between -20°C and 60°C for relative permittivity and electric conductivity and between -20°C and 80°C for breakdown voltage. The aim is to electrically characterize these liquids and to develop experimental models to be used in numerical simulations. Mathematical models of electric properties are essential for understanding the physical phenomena that can affect the performance of EHD systems. The development of these models can then help design more reliable EHD devices and optimize their performance.
In this paper, the impact of phase change material (PCM) integration into building envelopes is evaluated, considering a coastal mediterranean climate. PCM integration represents an innovative technology to lower construction’s heating and cooling loads. A case study was conducted on PCM integration into a Lebanese structure’s envelope where the thermal performance and energy effectiveness were assessed. A significant reduction was observed for both cooling and heating loads. Simulations revealed that the optimal PCMs were those whose melting temperatures were between 21 °C and 24 °C under the Mediterranean weather conditions, showing the importance of selecting the appropriate PCM to enhance energy savings. The annual energy savings calculated were between 11% and 13.4%. The study also emphasized the impact of the specified heating and cooling temperatures within the comfort range on the effectiveness of PCM integration. The results show that optimal PCM selection is a function of the weather conditions and indoor temperature settings.
4 June 2018 in IEEE Transactions on Industry Applications
This paper is an experimental study on electroconvective flows produced by an asymmetric electric field in a cavity. It is part of a scientific project aiming to develop electrohydrodynamic (EHD) flow actuator in order to enhance heat transfer and mixing efficiency in fluidic and microfluidic systems. In this study, the EHD flow is obtained by applying a dc voltage between two electrodes (cylinder/plane) immersed in a working liquid. The produced velocity fields strongly depend on the applied voltage. Whatever may be the applied voltage, the fluid goes from the cylinder toward the plate or the other way round. The velocity fields obtained by particle image velocimetry for different potentials are analyzed in both cases with the usual mechanisms (injection and conduction) at the origin of the motion of the liquid. A discussion on the transition between injection and conduction phenomena is finally presented.