High-performance insulation pull rods are crucial for ensuring the safe and stable operation of gas insulated switchgear (GIS). Currently, light-weight and high-strength aramid fibers serve as the primary reinforcement material in epoxy resin composites for insulation pull rods. However, the smooth surface and low chemical reactivity of aramid fibers severely limit their widespread application. This study proposes using the coordination of Ca2+ to graft fluorine-containing silane coupling agents (AFS) targeted on the surface of aramid fibers, thereby roughening the fiber surface and activating surface activity. This enhances the interfacial bond strength and insulation performance of aramid fiber/epoxy resin (AFEP) composites. The electrical and mechanical properties demonstrate that the flashover voltage, breakdown field strength, and shear strength are increased by 37.97%, 78.47%, and 78.44% respectively. The mechanism whereby Ca2+ coordination targets and enhances the insulation properties of AFEP was elucidated using combined DFT calculations and MD simulations.
Epoxy resin (EP) is an outstanding polymer material known for its low cost, ease of preparation, excellent electrical insulation properties, mechanical strength, and chemical stability. It is widely used in high- and ultra-high-voltage power transmission and transformation equipment. However, as voltage levels continue to increase, EP materials are gradually failing to meet the performance demands of operational environments. Thus, the development of high-performance epoxy resin materials has become crucial. In this study, a combined treatment using plasma and a fluorine-containing coupling agent was employed to fluorinate graphene nanosheets (GNSs), resulting in DFGNSs. Different concentrations of GNSs/DFGNS-modified EP composites were prepared, and their effects on enhancing the surface insulation properties were studied. Tests on surface flashover voltage, surface charge dissipation, trap distribution, and surface resistivity demonstrated that both GNSs and DFGNSs significantly improve the insulation properties of EP materials. Optimal improvement was achieved with a DFGNS content of 0.2 wt%, where the flashover voltage increased by 16.23%.
17 February 2025 in IEEE Transactions on Dielectrics and Electrical Insulation
This paper explores the behavior of charge transport and the surface electrical properties of epoxy spacers within high voltage alternating current (HVAC) gas-insulated switchgear (GIS), which may be exposed to the DC-AC switching electric field at the end of DC ice-melting. Simulation and experimental results reveal that increasing DC voltage and duration enhance charge accumulation at the gas-solid interface, whose polarity aligns with the electrodes. When the electric field transitions to AC, charge accumulation occurs gradually during the half-cycle where the voltage polarity matches the charge polarity. However, during the half-cycle of opposite polarity, the probability of flashover increases dramatically. Positive polarity DC charging leads to greater charge accumulation and more severe electric field distortion than negative polarity, thereby increasing the risk to the insulation performance.