Determining the constitutive properties that describe the incipient hydraulic behavior of the materials, including the matrix domains and the distribution of macro and micropores, is crucial to analyzing the preferential water flow in saturated soils, ks, and unsaturated, ku. This study focused on determining the hydraulic conductivity in porous media under total and partial saturation conditions. The infiltration characteristics of three reconstituted soils were evaluated using five suction ranges employing conventional permeameters, an automated dual system, and mini-disk infiltrometers. The experimental cycles were carried out in granular soils with mixtures of diatomaceous soils, iron oxide (Fe2O3), and calcium carbonate (CaCO3) in 5–40% proportions. The differences between the granular microstructures of each material and the different hydraulic interaction mechanisms (suctione levels) significantly affected the values of ks and ku and the coupling between the pore domains and the defined water regime. Additionally, a lower impact was observed in the data set exposed to higher percentages of Fe2O3 and CaCO3 in different suction ranges, mainly due to a tension effect (meniscus) generated by suction in the granular skeleton. Since both parameters are mutually correlated and have a similar impact between methods and soil cores, ks and ku must be optimized simultaneously in each mechanism analyzed. The main findings of this work result in the confirmation that the unsaturated permeability decreases as suction is imposed on the sample. As well as the addition of different materials with Particle Size Distribution finer than the base sample, it also reveals a reduction in hydraulic conductivity, both saturated and unsaturated.
En diversos estudios es necesario determinar la magnitud de caudales extremos en un río. Disponiendo de un adecuado registro histórico de caudales es posible ajustar una función de densidad de probabilidad (fdp) que permita estimar eventos asociados con un alto periodo de retorno (i.e. 100 años). En cuencas no-instrumentadas, como son la mayoría de cuencas en el mundo, se recurre a otras metodologías como por ejemplo el Hidrograma Unitario Sintético propuesto por el Servicio de Conservación de Suelos – USA (HU-SCS). Se evaluó el modelo HU-SCS en cuencas del departamento Norte de Santander (COL), en su capacidad para estimar caudales extremos, y explorar su posible regionalización. La evaluación se realiza mediante la comparación de estimaciones de Q100, mediante el método de Factores de Frecuencia y el modelo HU-SCS. Series temporales de caudal y precipitación se obtuvieron de la red IDEAM, seleccionando 19 cuencas en función de su área de drenaje, densidad de estaciones climatológicas y longitud del registro, caracterizadas geomorfológicamente utilizando ArcMap™ sobre el modelo digital de elevación ASTER-GDEM. Utilizando información disponible sobre geología, suelos, cobertura vegetal, y asumiendo una condición antecedente de suelo húmeda (AMC-III) se obtuvieron valores de la mediana del error relativo Q100 (ε-Q100) de +507% y +406%, para las fdp Gumbel y Log Pearson. Para una condición antecedente de suelo seca (AMC-I) ε-Q100 bajo a +36% y +17%. Fue posible minimizar ε-Q100 mediante calibración del parámetro Número de Curva (CN). No se encontró una función de regionalización satisfactoria para CN. Aplicando SCS-HU para condición AMC-III se sobreestima en gran medida el Q100. Es posible minimizar el error al considerar AMC-I y reducir CN, situación contra-intuitiva pues caudales extremos se asocian con condiciones meteorológicas húmedas (i.e. Año Niña). Se debe investigar mejoras en la caracterización de la lluvia y suelos en Norte de Santander.https://doi.org/10.22463/0122820X.1743
Las estructuras de protección cumplen un papel importante en relación con la reducción del riesgo en áreas con amenaza alta por inundación. Estas se consideran importantes para identificar deficiencias emergentes y así, intervenir de manera efectiva. La problemática analizada involucra la comparación de obras de reducción enfocadas a proyectos orientados a la protección, es decir, la reducción de la amenaza en áreas de mayor riesgo de inundación. El objetivo de la investigación es comparar tipos de obras de protección en áreas con mayor riesgo de inundación de la Quebrada Tonchalá del municipio de San José de Cúcuta. El método empleado en esta investigación corresponde al tipo aplicada, la cual está relacionada profundamente con la investigación básica, ya que, aunque dependen de conocimientos iniciales adquiridos, se caracteriza por poseer un mayor enfoque de la aplicación de conocimientos a la práctica. Además de esto, se efectúa un análisis multicriterio mediante el método AHP (Analytical Hierarchy Process) para la selección de la obra de protección al sector de estudio, este método se enfoca en evaluar la idoneidad con base a diferentes lineamientos propuestos para una adecuada evaluación de aspectos que inciden directamente en la toma de decisiones. Como resultado, se establece la construcción de un muro de hormigón como estructura de protección para la reducción del riesgo por amenaza alta de inundación, el cual obtuvo una ponderación final del 35 % sobre las demás alternativas, lo cual demuestra que esta es la que mejor se adapta a las condiciones del área de estudio.
In rivers, longitudinal walls are protective structures that are directly supported on the riverbank are frequently used as hydraulic prevent the current from eroding the bank and causing scouring. However, these structures have the potential to block flow and produce erosive processes that progressively worsen scour in their area, leading to faulting and other problems. The current study used Flow-3D software to understand the scour process at the base of longitudinal walls in rivers with a well-graded granular bed. Experimental data from a physical model replicating a river with a longitudinal wall and a well-graded granular bed were used to validate the model. The investigation examined the average flow velocity and its effects on scour behavior along the longitudinal wall using the Flow-3D program. The findings showed that the Flow-3D model could improve the evaluation of debugging processes, because it provided a useful answer that closely matched the experimental data derived from the physical model. Validation with a 0.07 m mesh demonstrated that the Flow-3D model could faithfully simulate the scour process along the longitudinal wall. Overall, the findings of this study suggest that the Flow-3D software can be a useful tool for predicting the scouring process in rivers with well-graded granular beds and longitudinal walls. This is particularly important for engineers and researchers who are interested in designing and optimizing hydraulic structures to mitigate the effects of scouring, because it provided a useful answer that closely matched the experimental data derived from the physical model
Esta investigación se centra en la estimación de caudales extremos para cuencas hidrológicas en la región nororiental andina de Colombia, considerando periodos de retorno de 10, 50, 100 y 200 años. Se aplicó la prueba de bondad y ajuste de Kolmogórov-Smirnov a 39 estaciones limnimétricas en los departamentos de Boyacá, Cundinamarca, Santander y Norte de Santander. Se evaluaron funciones de distribución como Normal, Log Normal, Log Pearson y Gumbel. Se aplicaron las ecuaciones de amplificación de caudales no instantáneos de Fuller, Tonini (1939), Tonini (1969), Cotecchia (1965) y Tucci (1991). Los resultados revelan que la distribución Normal demostró ser la más apropiada, abarcando un 36% de las estaciones analizadas y que los modelos de Tonini (1939) y Cotecchia tienden a sobreestimar, mientras que los de Fuller, Tonini (1969) y Tucci son más conservadores para la estimación de caudales extremos no instantáneos para los periodos de retorno analizados. La selección de un modelo de amplificación incorrecto, puede incurrir en el incremento de costos de las obras hidráulicas, pero también favorece el factor de seguridad, por lo cual se recomienda la calibración de los modelos de amplificación de los caudales no instantáneos y el aumento de estaciones limnigráficas en la región Nororiental Andina de Colombia.
1 November 2019 in Journal of Physics: Conference Series
In every branch of science, the classification of the object of study shows the degree of understanding reached. Hydrology seeks this sorting system that classifies watersheds globally, a highly complex issue given the degree of heterogeneity of climates, geomorphology, vegetation cover, soils and geology. This project provides ideas on the possibilities of classification of basins in the southern region of the Andean zone in Colombia, from hydrological similarity point of view, evaluated by means of "signatures" that synthesize the hydrological functioning of the basin. Five signatures were considered: Runoff coefficient, base flow index, slope of the flow duration curve, discharge-precipitation elasticity, and hydrograph rising limb density. Geomorphological characteristics and values of hydrological signatures were determined for 25 catchments. Two classification methodologies were implemented: k-means clustering and classification and regression trees. The grouping identified two groups for base flow index, rising limb density and slope of the flow duration curve firms, and three groups for the remaining runoff coefficient and streamflow-precipitation elasticity. No significant correlations were found between hydrological signatures and climatic and geomorphological characteristics, suggesting a degree of complexity within hydrological processes that require the inclusion of other components such as vegetation and soils characteristics. By applying regression trees, the basins were grouped into 4 classes, with the slope of the flow duration curve being the main discriminator and the rising limb density in the second level. The importance of the flow duration curve as an indicator of hydrological processes and the rising limb density as an indicator of the climatic component, the driving force of said processes, is highlighted.