Porous lead zirconate titanate (PZT) films have the potential to be utilized in a variety of electronic applications. The combination of sol–gel techniques with molecular self-assembly facilitates the formation of porous films with a uniform distribution of nanometer-sized pores. The study of the pore structure of PZT films annealed at temperatures ranging from [ ]C to [ ]C using ellipsometric porosimetry (EP) has revealed that the process of crystallization plays a crucial role in determining the pore structure. The pore size in PZT films exhibits a rapid increase of approximately one order of magnitude upon heat treatment at [ ]C, which can be attributed to structural rearrangement during crystallization. This phenomenon differs from the one observed in porous organosilica films prepared through a similar self-assembly process, where crystallization does not occur and the pore size is not significantly dependent on the heat treatment temperature.
4 April 2025 in The Journal of Physical Chemistry B
Organosilica films, composed of a silicon oxide network with terminal methyl groups, are widely utilized in various applications, including microelectronics. Many of these applications require high hydrophobicity and good mechanical properties, which pose a significant challenge because the Si–CH3 groups disrupt the Si–O–Si network. This issue becomes particularly pronounced in porous films. Here, we investigate whether material properties can be tuned by simply altering the spatial arrangement of methyl groups. To achieve this, we prepared copolymer films with one or two methyl groups bonded to a silicon atom, while maintaining a constant total amount of methyl groups. The films were deposited using a sol–gel technique combined with template self-assembly. The precursor content was varied to compare films with different proportions of Si–CH3 and Si(–CH3)2. Film characterization included FTIR, ellipsometric porosimetry, AFM, and WCA measurements and dielectric constant evaluations. Our findings indicate that precursors containing dimethyl groups enhance the connectivity of the Si–O–Si network, resulting in a higher Young’s modulus and smaller pore size compared to films with an equivalent amount of methyl groups. However, the lower thermal stability of dimethyl bonds limits the thermal budget of these films. Thus, the spatial arrangement of organic groups within the polymer structure can be employed to tune material properties. These results expand the understanding of organic–inorganic hybrid materials and offer novel approaches for their applications.
Organosilica films with a silicon oxide network and terminal methyl groups are widely used for various applications, including microelectronics. Most of them require high hydrophobicity and good mechanical properties, which is a challenge because Si–CH3 blocks some directions of the metal–oxide network. Here, we discuss an alternate way to prepare organosilica films in which the methyl group is changed to dimethyl. The films were deposited by the sol–gel technique using a non-ionic surfactant to provide porosity. The precursor content was varied to compare the films with different contents of Si–CH3 and Si(–CH3)2. The characterization of the films includes FTIR, ellipsometric porosimetry, PFQNM AFM, wetting contact angle, and dielectric constant. We found that the use of precursors containing dimethyl groups leads to an increase in Si–O–Si network connectivity and hence a higher Young's modulus value compared to films containing the same amount of methyl groups. However, the lower thermal stability of the dimethyl bonds leads to some deterioration of hydrophobic behavior and related properties. These new results extend the knowledge of organic-inorganic hybrid materials and provide new approaches for their applications.