IJTech International Journal of Technology

Pollution continues to experience a rapid increase so cities in the world have required the use of renewable energy. One of the keys that can prevent climate change with a sustainable system is renewable energy. Renewable energy production, especially for hybrid systems from biomass and wind, is the objective of the analysis in this work. The potential of feedstock for different biofuels such as bio-diesel, bio-ethanol, bio-methane, bio-hydrogen, and biomass is also discussed in this paper. The sustainability of the energy system for the long term is the main focus of work in this investigation. The configuration of the hybrid system between biomass energy and wind energy as well as some problems from various design factors are also presented. Based on the findings, this alternative energy utilization through biomass-based hybrids can save costs and improve environmental conditions, especially for the electrification of off-grid rural areas. This paper will provide important information to policymakers, academics, and investors, especially in carrying out the development and factors related to the utilization of wind-biomass-based hybrid energy systems.

Presently, biomass is mostly utilized as co-fuel in coal combustion in view of energy diversification and emission reduction. However, since the coal content of bio-briquettes is high (up to 80% in this study), gas emissions such as those of SO_x still occur. Therefore, the introduction of SO₂adsorbent is common in coal briquette or bio-briquette combustion. A calcium-based material is usually used for this goal. The aim of this study was to observe the effects of desulfurization temperature and Ca/S ratio (Ca = calcium content in adsorbent; S = sulfur content in coal and biomass) on desulfurization efficiency and kinetics. The ratio of coal to biomass (palm kernel shell/PKS) was fixed at 90:10 (wt/wt) and the ratios of Ca to S were varied at 1:1, 1.25:1, 1.5:1, 1.75:1 and 2:1. The mixtures of coal, PKS and adsorbent were briquetted at a molding pressure of 6 ton/cm² with Jatropha curcas seeds and starch mixture as binding agents. Desulfurization was performed within a temperature range of 300 to 500°C for 720 seconds at an airflow rate of 1.2 L/min. The results showed that the highest desulfurization efficiency (90.6%) was associated with the Ca/S ratio of 2:1 and temperature of 400°C. Moreover, the highest reaction rate constant of desulfurization was 0.280 min^-1.