The Middle-Upper Cambrian Xixiangchi carbonates in the Sichuan Basin have been pervasively dolomitized. In the presented work, petrographic investigation revealed three generations of the Xixiangchi dolomites, consisting of dolomicrite (D1, 5–20 μm) with a planar-s to non-planar texture, fabric destructive dolomite (D2, 50–150 μM) with a planar-s to planar-e texture, and saddle dolomite (D3, 300 μm to 4 mm) with a planar-s to planar-e texture. D1 and D2 dolomites are presented as matrix dolomites, whereas D3 dolomites are observed as fracture-filling dolomites. Compared with the matrix D1 and D2 dolomites, which are interpreted as products of dolomitization under near-surface or at shallow burial conditions, the depleted δ¹³C and δ¹⁸O values of D3 than D1 and D2 dolomites are probably caused by the temperature-controlled isotopic fractionation within an increasing fluid–rock interaction at burial. The enriched Mn, Sr, and Ba concentrations of D3 than D1 and D2 dolomites suggest a newly introduced type of diagenetic fluids, which is probably related to the upwelling of magmatic activities (Emeishan large igneous province). By contrast, the abnormally depleted Fe concentration in D3 dolomites is attributed to its preferential incorporation into other solid phases rather than its true concentration. The similar rare earth element (REE) partition patterns of D1 and D2 dolomites demonstrate similar dolomitization fluids related to seawater or marine-origin fluids. The hydrothermal-derived D3 dolomites exhibit a different REE partition pattern by contrast. The negative Eu anomalies of D3 dolomites may represent hydrothermal fluid cooling or an association with intermediate-felsic igneous rocks. The findings of the presented work would enhance our understanding on the hydrothermal dolomitization of the Middle-Upper Cambrian Xixiangchi Formation.

The Middle-Upper Cambrian Xixiangchi Formation in the Sichuan Basin is regarded as an important reservoir with great potential for hydrocarbon exploration. It is previously indicated that the Xixiangchi carbonates have experienced extensive dolomitization, however, the origin of dolomitizing fluids and the dolomitization mechanism still remain uncertain. In this study, a set of petrographic and geochemical examinations, including rare earth elements (REE) and isotopic (C, O, and Sr) compositions were used to trace the origins of dolomitizing fluids and associated diagenetic processes. The petrographic examination revealed three types of matrix dolomites (D1, D2, D3) and one cement saddle dolomite (SD). These phases have crystal size ranges of less than 30 μm (very fine to fine crystals, D1), 30–100 μm (fine to medium crystals, D2), 100–300 μm (medium to coarsely crystalline dolomite, D3), and 0.3–4 mm (fracture filling cements, SD), respectively. D1 is characterized by non to very weak luminescence, weakly negative Ce anomalies (Ce/Ce* = 0.84 ± 0.02), strongly negative Eu anomalies (Eu/Eu* = 0.65 ± 0.03), and high ⁸⁷Sr/⁸⁶Sr ratios (0.71062 ± 0.00122). In combination with δ¹³C (−1.5‰ ± 0.2‰) and δ¹⁸O (−9.7‰ ± 0.5‰) compositions, D1 is interpreted to be formed by penecontemporaneous dolomitization in the near-surface environment with seawater as the dolomitizing fluid. In contrast, D2 is characterized by intercrystalline pores, dirty crystal surfaces, similar δ¹³C (−1.4‰ ± 0.4‰) compositions but higher δ¹⁸O (−8.9‰ ± 0.7‰) compositions, and lower ⁸⁷Sr/⁸⁶Sr ratios (0.70992 ± 0.00035), similar Ce anomalies (Ce/Ce* = 0.87 ± 0.04) and higher Eu anomalies (Eu/Eu* = 0.85 ± 0.04). The coarser D2 is regarded to be formed by the post-penecontemporaneous seepage-reflux dolomitization or by recrystallization of D1 dolomite in a near-surface or shallow burial environment. D3 is distinguished by a cloudy core with clear rims, showing slightly higher Eu anomalies (Eu/Eu* = 0.88 ± 0.02) and similar Ce anomalies (Ce/Ce* = 0.88 ± 0.02) than those of D1 and D2. Combined with the δ¹⁸O compositions (−10.4‰ ± 0.4‰) and ⁸⁷Sr/⁸⁶Sr ratios (0.70989 ± 0.00048), D3 is thought to be formed by the overgrowth or recrystallization of D1 and D2 dolomites in a shallow to moderate burial environment. The fractures filling SD dolomite consists of nonplanar and much coarser crystals with undulatory extinctions and brighter red luminescence. The lower δ¹⁸O (−11.1‰ ± 0.3‰) compositions, lower negative Eu anomalies (Eu/Eu* = 0.70 ± 0.01) of SD than the matrix dolomites, and similar Ce anomalies (Ce/Ce* = 0.83 ± 0.01) are indicative of hydrothermal dolomitization, with possible fluids associated with the magma during the period of Emei taphrogenic movement. In addition, the ⁸⁷Sr/⁸⁶Sr ratios (0.70941 ± 0.00003) of SD suggest probable origin from the coeval seawater partially. Therefore, SD dolomite is interpreted to be formed by hydrothermal dolomitization with mixed dolomitizing fluid of seawater and hydrothermal fluids. In summary, all the matrix dolomites have almost the same ΣREE concentrations and exhibit similar near-flat REE partition patterns with weak LREE enrichments, weakly negative Ce anomalies, and negative Eu anomalies. Such characteristics of REE compositions are indicative of similar evolved dolomitizing fluid, such as seawater or seawater- derived fluids. By contrast, SD dolomites have a different REE partition pattern with left-leaning characteristics, LREE depletions, and negative Eu anomalies, thus suggesting a different dolomitizing fluid source from the matrix dolomites. In addition, the development of intercrystalline pores associated with D2 dolomite makes it more likely to be a potential reservoir, indicating that the dolomitizing history of carbonate has a strong influence on the quality of potential dolomite reservoirs.

A special type of sandstone in which carbonate rock fragments (CRFs) dominate the composition developed in the Upper Triassic Xujiahe Formation’s fourth member (Xu4) in the western Sichuan Basin, known as calcareous sandstone. Calcareous sandstones are widely distributed in the western Sichuan and is the main production target of tight sandstone gas in the Sichuan Basin. In this study, thin sections, porosity–permeability testing, scanning electron microscopy, and X-ray diffraction are applied to examine the characteristics and control factors for high-quality reservoirs in the calcareous sandstones, with a view to providing guidance for natural gas exploration and development in calcareous sandstones. The results show that the calcareous sandstone belongs to litharenite, with an average framework grain composition of 30% quartz, 1% feldspar, and 69% rock fragments, while the Xu4 sandstone has a high quartz content (average content of 71%). Primary intergranular pores are the main storage space, and the reservoir quality is quite poor. Under the influence of different parent rock properties of sandstones, there are obvious differences in the composition of framework grains between the calcareous sandstone and the ordinary Xu4 sandstone, which in turn affects the reservoir storage space, diagenesis, and reservoir quality. High-energy depositional conditions, low content of late cements, and the development of fractures are the main controlling factors for the formation of high-quality reservoirs in Xu 4 calcareous sandstones.

The Upper Triassic Xujiahe Formation in the western Sichuan Basin is rich in natural gas resources and is one of the main tight sandstone gas-producing layers in the Sichuan Basin. Taking the tight sandstone of the second member of the Xujiahe Formation (Xu-2 Member) in the western Sichuan Basin as the study target, based on the analysis of the rock sample, a thin section, scanning electron microscopy, inclusion, the carbon and oxygen isotope, the petrological characteristics, the reservoir properties, the diagenetic sequences, and the pore evolution processes were revealed. The tight sandstones are composed of litharenite, sublitharenite, and feldspathic litharenite with an average porosity of 3.81% and a permeability mainly ranging from 0.01 to 0.5 mD. The early to late diagenetic stages were revealed, and the diagenetic evolution sequence with five stages was constructed. The Xu-2 sandstones were subdivided into three different types, and each type has its own tightening factors and processes. In the quartz-rich sandstone, the compaction and pressure solution were the primary causes of reservoir tightening, while late fracturing and dissolution along fractures were the main factors improving reservoir properties. In the feldspar-rich sandstone, early dissolution was a primary factor in improving porosity, while carbonate and quartz cements generated by dissolution contributed to a decrease in porosity. In the rock-fragment-rich sandstone, chlorites formed in the early stage and dissolution were the main factors of reservoir quality improvement, while the authigenic quartz formed in the middle diagenetic stage was the primary cause of reservoir tightening. Four major source-to-sink systems were identified in the western Sichuan Basin and they have different reservoir characteristics and reservoir quality controlling factors. This study will contribute to a deeper understanding of the characteristics, diagenetic evolution, and tightening process of tight sandstone reservoirs, effectively promoting scientific research and the industrial development of tight sandstone gas in the Xu-2 Member of the Sichuan Basin.

By employing thin section analysis, scanning electron microscopy (SEM), homogenization temperatures of fluid inclusions, and carbon–oxygen isotope analysis of carbonate cements, this study conducted a temporal-quantitative investigation into the porosity evolution of relatively high-quality reservoirs in the Second Member of the Xujiahe Formation (Xu-2 Member) in the Xinchang area of western Sichuan. The analysis focused on quantifying porosity loss due to compaction, cementation, and porosity enhancement from dissolution. Results indicate that compaction exerted the most significant impact on reservoir quality in the Xu-2 Member, causing over 70% of total porosity loss. Cementation processes, including carbonate cements, silica cements, and authigenic chlorite, further degraded reservoir properties. Authigenic chlorite precipitated earliest at burial depths of 600–800 m, while authigenic quartz and carbonate cements persistently affected the reservoir at depths of 2000–5000 m, reducing porosity by at least 10% (up to 21%). Dissolution processes initiated at approximately 3500 m burial depth, generating secondary porosity of ≥2%, with a maximum increase of 16%. Integrating these findings with the natural gas accumulation history, the coupling relationship between pore evolution and gas accumulation was elucidated. The study reveals that reservoir tightness in the Xu-2 Member developed at burial depths of 4050–5300 m, with large-scale gas accumulation predominantly occurring prior to reservoir densification. The findings provide critical guidance for identifying high-quality tight sandstone reservoirs and optimizing exploration targets in the Xu-2 Member of the Xinchang area, Western Sichuan Basin, thereby supporting efficient development of regional tight gas resources.