At least 32 case histories have shown that liquefaction can occur in gravelly soils (both natural deposits and manmade reclamations) during severe earthquakes, causing large ground deformations and severe damage to civil infrastructures. Gravelly soils, however, pose major challenges in geotechnical earthquake engineering in terms of assessing their deformation characteristics and potential for liquefaction. In this study, aimed at providing valuable insights into this important topic, a series of isotropically consolidated undrained cyclic triaxial tests were carried out on selected sand–gravel mixtures (SGMs) with varying degrees of gravel content (G_c) and relative density (D_r). The pore water pressure generation and liquefaction resistance were examined and then further scrutinized using an energy-based method (EBM) for liquefaction assessment. It is shown that the rate of pore water pressure development is influenced by the cyclic resistance ratio (CSR), G_c and D_r of SGMs. However, a unique correlation exists between the pore water pressure ratio and cumulative normalized dissipated energy during liquefaction. Furthermore, the cumulative normalized energy is a promising parameter to describe the cyclic resistance ratio (CRR) of gravelly soils at various post-liquefaction axial strain levels, considering the combined effects of G_c and D_r on the liquefaction resistance.

Shear wave velocity (V_S) measurements are widely used to characterize geomaterials, evaluate small-strain stiffness, and develop indirect approaches for estimating the liquefaction resistance of various soil types. In this study, the bender element method was employed to investigate the V_S characteristics of sand–gravel mixtures (SGMs), with the aim of clarifying the combined effect of key factors such as gravel content (G_C), relative density (D_r), packing state, and soil fabric. Laboratory tests were performed on reconstituted specimens composed of two sandy soils and pea gravel with G_C of 0, 10, 25, 40, 60, 80 and 100% and D_r of 20, 30, 45 and 60%. Specimens were prepared using wet tamping (WT) and air pluviation (AP) techniques. V_S measurements were conducted under effective confining stresses (${{\sigma }^{\prime }}_0$) of 50, 100, 150 and 200 kPa. The results show that the V_S of SGMs increases with increasing D_r and ${p^{\prime }}_0$, whereas the influence of G_C depends on the limiting and threshold sand contents. The effect of soil fabric was found to be marginal. Furthermore, the combined effects of G_C and D_r on V_S can be uniquely captured using the equivalent void ratio approach for SGMs with sand-dominated microstructures, while the skeleton void ratio approach is more appropriate for SGMs with gravel-dominated microstructures.