Foam pollution in the tailwater discharge from coastal power plants poses a significant challenge. However, the mechanisms underlying foam formation and stability remain understudied, which hinders the development of effective control strategies. This study investigated the impacts of temperature and algal concentration on foam stability in tailwater discharge from coastal power plants through simulation experiments to elucidate mechanisms of foam stability. A laboratory simulation device was developed to adjust temperature and algal concentration and measure foam layer height, half-life, bubble diameter, surface tension, and viscosity. This device was used to replicate foam scenarios typical of coastal power plant tailwater discharge to analyze the effects of temperature and algal concentration on foam stability through comprehensive data collection and analysis across various operational conditions. The findings revealed that foam stability decreased with increasing temperatures (15–45 °C). However, during hot summer months, higher temperatures (range of 30–40 °C) hindered foam dissipation owing to algal blooms and the release of surface-active substances. The functional relationship between foam stability index (half-life, foam layer height, bubble diameter) and temperature and algae concentration was established, which provides a scientific basis for predicting foam stability under different conditions. This research elucidates the complex dynamics of foam in the tailwater discharge from coastal power plants and provides insights for developing more effective foam control strategies, potentially mitigating adverse impacts on the marine ecosystem. In future research, by adding experimental conditions such as pH, ionic strength, and different types of protein polysaccharides, a more comprehensive understanding of the mechanism of bubble generation can be achieved, providing more accurate foam suppression optimization solutions for future engineering practices.

Coastal power plants draw seawater from the open ocean through their cooling-water circulation systems. The cooling water falls over an overflow weir inside the siphon well, entraining large quantities of air, and generates a foam pollution plume upon discharge to the sea. By combining physical model experiments with numerical simulation, this study investigates the key factors governing foam stability and the aeration behavior of the water downstream of the siphon-well overflow weir. The principal conclusions are as follows: among the three single-factor variables tested in controlled laboratory conditions—temperature, salinity, and shellfish-flesh suspension concentration—the biological substance proxy showed the strongest effect on foam stability; when the shellfish-flesh suspension concentration reaches 20% (mass/volume basis, independently prepared), the foam volume and half-life increase by factors of 1.4 and 3.36, respectively, relative to the 4% baseline condition. When the dimensionless aeration depth z/z₉₀ < 0.75, the air-concentration profile rises relatively slowly with depth, whereas it increases more rapidly as the free surface is approached. Within the investigated viscosity range of 1.0–8.3 mPa·s (1.0 mPa·s for the pure-water control and 1.5–8.3 mPa·s for the measured viscosities of the 4–20% shellfish-flesh suspensions), the cross-sectional mean air concentration shows an overall decreasing trend as the liquid-phase viscosity increases, and the total bubble number density decreases correspondingly. The findings provide a laboratory-based indication of the mechanisms that must be addressed in the development of physical foam-suppression technologies; confirmation against field discharge water is required.