Organic-rich hot Qusaiba shale is the primary source rock of most of the Paleozoic hydrocarbon reservoirs of eastern and central Arabia. Representative near-surface Qusaiba shale samples were collected and characterized from one of its outcrop sections at the Tayma quadrangle in northwest Saudi Arabia. The petrophysical and geochemical characterization indicated porosity and permeability of 8.2% and 2.05 nD, respectively, with good total organic carbon (TOC) of 2.2 mg/g and mature kerogen of gas-prone type III. The tight characteristics of the formation can lead to high capillary pressure and extensive post-fracking water retention, leading to flow blockage and a reduction in gas productivity. Three different surfactants and one ionic liquid, namely, Triton X-100, Triton X-405 and Zonyle FSO surfactants and Ammoeng 102 ionic liquid, were tested as additives to fracking fluid to investigate their effectiveness in optimizing its performance. The chemical solutions exhibited no sign of instability when exposed to solution salinity and temperatures up to 70 °C. The investigated chemicals’ performance was examined by measuring methane/chemical solutions’ surface tension and their ability to alter shale’s wettability. The results indicate that Zonyl FSO is the most effective chemical, as it is able to significantly reduce surface tension and, hence, capillary pressure by 66% when added at critical micelle concentration (CMC). Using Zonyl FSO surfactant at a maximum tested concentration of 0.2% induced a relatively smaller capillary pressure drop (54%) due to the drastic drop in the contact angle rendering shale very strongly water-wet. Such a drop in capillary pressure can lower the fracking fluid invasion depth and therefore ease the liquid blockage removal during the flowback stage, enhancing gas recovery during the extended production stage. Triton X-100 at CMC was the second most effective surfactant and was able to induce a quite significant 47% drop in capillary pressure when added at the maximum tested concentration of 0.05%. This was sufficient to remove any liquid blockage but was less likely to alter the wettability of the shale. Based on the findings obtained, it is suggested to reduce the blockage tendency during the fracking process and elevate any existing blockage during the flowback stage by using Zonyl FSO at CMC where IFT is at its minimum with a higher contact angle.
With growing electricity demand and an increasing focus on renewable energy, geothermal energy exploration is gaining prominence in Saudi Arabia. This study investigates the geothermal potential of the Riyadh region by integrating various geophysical data with geological information, providing a detailed image of the structural framework and thermal distribution. We generated a 2D density and susceptibility model using gravity and aeromagnetic data, constrained by well-logs information for sedimentary rocks. Distinct salt layers with low densities (2.15 g/cm3) were introduced in the model overlying the basement rocks, as well as unexposed faults, which may play a crucial role in the thermal regime in the study area. We produced a comprehensive thermal model extracted from the density and susceptibility model, along with temperature measurements from the Minjur Aquifer. The presence of the salt layer not only affects the geothermal gradient, but also suggests the potential for enhanced surface heat flow in specific areas. The results highlight the presence of a promising geothermal reservoir, the Minjur Formation, which exhibits significant potential for geothermal energy extraction due to its porosity, permeability, and sufficient thermal gradient ranging from 80 °C to 120 °C at depths of 2 to 3 km. These findings offer significant implications for Saudi Arabia’s transition to cleaner energy sources and support the future development of geothermal infrastructure in urban areas like Riyadh.