Clay/natural rubber (Clay–NR) nanocomposites are a sustainable material class with a wide range of applications. The type and amount of the filler added to the rubber matrix promote significant changes in the matrix properties. Montmorillonitic clays (MMT) are mineral, natural fillers. This study investigates the effect of a modified Brazilian polycationic MMT on the nanocomposite rheology and mechanical properties. The MMT was incorporated into a NR matrix in its natural state, and after modification by cation exchange (MMTNa) and organophilization (MMTORG), at concentrations of 2.5 and 5 phr (parts per hundred parts of rubber). The natural and modified clays were characterized by XRD, FTIR, BET, and SEM/EDS. Mechanical tests (tensile strength, elongation at break, and modulus at 100%) indicated that the use of MMTNa led to increased strength and modulus, whereas a minor decrease in the elongation was observed. However, the use of MMTORG yielded the most significant improvements in the mechanical properties. The rheology tests indicated that the Payne effect was not observed, and the strain-dependent behavior arises from matrix-dominated mechanisms, rather than disruption of a filler network. Vulcanization curves showed that the NR-MMTORG composites exhibited higher torque values, corroborated by higher crosslink densities. These findings highlight the critical role of cation exchange modification in optimizing MMT dispersion and interfacial interactions within NR matrices, providing design principles for high-performance sustainable nanocomposites.
Among the naturally abundant clays in the Earth’s crust, montmorillonite (MMT), a member of the smectite group, stands out for its versatility. Its interesting properties can be further improved by chemical processing with inorganic acids and reaction temperatures close to boiling. In this study, a Brazilian polycationic MMT was treated with a low-concentration (2M) aqueous solution of hydrochloric acid at 60 and 70 °C for 5 h. The resulting modified clay was then employed in the purification of post-consumption oil (PCO), specifically soybean oil. The effect of the modification variables of the clay and also the purification parameters (time and temperature) were investigated, comparing the adsorptive and purification capacities of the modified MMT with those of the natural and a commercial clay sample. The characterization of the MMT (raw and modified) was carried out by bulk density, moisture content, plasticity limit, BET, SEM/EDS, XRD, and FTIR, whereas the characterization of the PCO, as-received and after purification, involved the analyses of apparent density, relative flow time, UV-Vis spectrophotometry, and acid value. The results show that light acid activation, especially at 70 °C, promoted a significant increase in the surface area up to 96% and the adsorption capacity of the clay. The oil purification showed good results in all tests, with the best condition being 70 °C for 24 h with the C70 clay. Thus, the satisfactory results represent an economy of time and energy.