Experimental investigation on the relation of grinding induced surface residual stresses (RS) with stress corrosion cracking (SCC) susceptibility and electrochemical behaviour was conducted on 316L austenitic stainless steel in 3.5% sodium chloride aqueous solution. Grinding was done with the same process parameters to lower the effect of other known parameters on SCC initiation. The corrosion behaviour was characterised by Potentiodynamic and galvanostatic tests. The latest was performed under fixed current density in metastable region. There was a strong relationship between the electrochemical results with RS magnitude. Microscopic investigation showed that the RS induced by grinding could not be the reason for SCC and the dominant defect observed was pitting for all the specimens. The time needed for the breakdown of the passive layer was exponentially related to RS level but the propagation of pits was nearly the same for all the specimens.
29 September 2022 in International Journal of Computer Integrated Manufacturing
In this paper, the blank shape is optimized by three approaches: a slow and accurate method, sensitivity analysis, a fast and approximate method, fuzzy logic decision-making, and finally, a novel quick and precise way was introduced by a combination of sensitivity analysis and fuzzy logic. It is shown that by using hybrid fuzzy logic-sensitivity, the number of iterations has been reduced down to 1 iteration in both cylindrical and square punch forming when the allowable geometrical error was considered to be less than the 1% of target size. The fuzzy logic code was written in Matlab software, and commercial finite element code Abaqus was used to simulate the forming process. Also, the results of the simulations obtained from finite element method analysis were verified experimentally on AL1050-O sheet for two different cylindrical and square die configurations. There was close agreement between the results of simulations and experiments. The difference was within the acceptable range of almost 3.5% in the square die and 1.8% in the cylindrical die.