The introduction of renewable energy sources (RESs) in the electricity grid mix is essential for a greener world. Wind offshore energy, known for its high flexibility and social acceptance, plays a significant role in this transition. However, the disposal of non-recyclable epoxy–GFRP wind blades produced and installed in the 1990s and 2000s poses environmental challenges. This study explores the development of a novel wind blade using sustainable materials, aiming to enhance eco-friendliness. A comparative life cycle assessment (LCA) highlights the environmental benefits of replacing epoxy with a thermoplastic recyclable resin in GFRP blades. The findings demonstrate a substantial reduction in environmental footprint, with a 30% decrease in climate change impact, a 97% reduction in freshwater ecotoxicity and a 95% reduction in marine eutrophication. It is evident from the LCA that the replacement of epoxy with a thermoplastic recyclable resin in a GFRP blade substantially reduces its environmental footprint and significantly contributes to the circular economy of RESs.
Polyvinyl alcohol is the most commercially water-soluble biodegradable polymer, and it is in use for a wide range of applications. It shows good compatibility with most inorganic/organic fillers, and enhanced composites may be prepared without the need to introduce coupling agents and interfacial modifiers. The patented high amorphous polyvinyl alcohol (HAVOH), commercialized with the trade name G-Polymer, can be easily dispersed in water and melt processed. HAVOH is particularly suitable for extrusion and can be used as a matrix to disperse nanocomposites with different properties. In this work, the optimization of the synthesis and characterization of HAVOH/reduced graphene oxide (rGO) nanocomposite obtained by the solution blending process of HAVOH and Graphene Oxide (GO) water solutions and ‘in situ’ reduction of GO is studied. The produced nanocomposite presents a low percolation threshold (~1.7 wt%) and high electrical conductivity (up to 11 S/m) due to the uniform dispersion in the polymer matrix as a result of the solution blending process and the good reduction level of GO. In consideration of HAVOH processability, the conductivity obtained by using rGO as filler, and the low percolation threshold, the nanocomposite presented here is a good candidate for the 3D printing of a conductive structure.