Bin Cai

Dr. Bin Cai

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 November 2024 in Sensors
Verified
Journal Article
Open access
PDF file
HLHan Liu
Han Liu
Simon LaflammeSimon Laflamme
Simon Laflamme
BCBin Cai
Bin Cai
PLPing Lyu
Ping Lyu
SSSri Sritharan
Sri Sritharan
Kejin WangKejin Wang
Kejin Wang
This paper explores the development of 3D-printed self-sensing Ultra-High Performance Concrete (UHPC) by incorporating graphite (G) powder, milled carbon microfiber (MCMF), and chopped carbon microfiber (CCMF) as additives into the UHPC matrix to enhance piezoresistive properties while maintaining workability for 3D printing. Percolation curves were established to identify optimal filler inclusion levels, and a series of compressive tests, including quasi-static cyclic, dynamic cyclic, and monotonic compressive loading, were conducted to evaluate the piezoresistive and mechanical performance of 29 different mix designs. It was found that incorporating G powder improved the conductivity of the UHPC but decreased compressive strength for both mold-cast and 3D-printed specimens. However, incorporating either MCMF or CCMF into the UHPC resulted in the maximum 9.8% and 19.2% increase in compressive strength and Young’s modulus, respectively, compared to the plain UHPC. The hybrid combination of MCMF and CCMF showed particularly effective in enhancing sensing performance, achieving strain linearity over 600 με. The best-preforming specimens (3G250M250CCMF) were fabricated using 3 wt% of G, 0.25 wt% of MCMF, and 0.25 wt% of CCMF, yielding a maximum strain gauge factor of 540, a resolution of 68 με, and an accuracy of 4.5 με under axial compression. The 3D-printed version of the best-performing specimens exhibited slightly diminished piezoresistive and mechanical behaviors compared to their mold-cast counterparts, yielding a maximum strain gauge factor of 410, a resolution of 99 με, and an accuracy of 8.6 με.

30 May 2026 in Modelling
Verified
Journal Article
Open access
PDF file
BCBin Cai
Bin Cai
SSSri Sritharan
Sri Sritharan
ETEugene Takle
Eugene Takle
CMChristopher Milliren
Christopher Milliren
While conventional wind towers operate at heights of 80 to 90 m across many regions, including the United States, emerging tower technologies enable higher hub heights that are expected to reduce the levelized cost of energy (LCOE) and increase profit margins. This paper investigates whether increased hub heights, as well as different turbine technologies, deliver measurable economic and performance benefits in wind-rich regions using measured and simulated wind data. First, a model for estimating hourly and monthly energy production is validated with data from a site in Minnesota. To evaluate the advantages of tall towers, the model is extended to estimate the annual energy production (AEP) at various hub heights across multiple sites using different wind datasets. The results confirm that simulated data can be effectively used for predicting AEP and capacity factors in wind-rich regions. Next, it is demonstrated that increasing the hub height by 20 m yielded an average 11% increase in AEP and an 18% reduction in LCOE. Finally, the integration of advanced turbine technologies with taller towers shows the potential to reduce the LCOE of wind power by 23% while increasing profit margins by over 40%.