The quality and safety of food is an increasing concern for worldwide business. Non-destructive methods (NDM), as a means of assessment and instrumentation have created an esteemed value in sciences, especially in food industries. Currently, NDM are useful because they allow the simultaneous measurement of chemical and physical data from food without destruction of the substance. Additionally, NDM can obtain both quantitative and qualitative data at the same time without separate analyses. Recently, many studies on non-destructive detection measurements of agro-food products and final quality assessment of foods were reported. As a general statement, the future of using NDM for assessing the quality of food and agricultural products is bright; and it is possible to come up with interesting findings through development of more efficient and precise imaging systems like the machine vision technique. The present review aims to discuss the application of different non-destructive methods (NDM) for food quality and safety evaluation.

Cost-effective biomass drying is a key challenge for energy recovery from biomass by direct combustion, gasification, and pyrolysis. The aim of the present study was to optimize the process of biomass drying using hot air convection (HA), infrared (IR), and combined drying systems (IR-HA). The specific energy consumption (SEC) decreased significantly by increasing the drying temperature using convective drying, but higher air velocities increased the SEC. Similarly, increasing air velocity in the infrared dryer resulted in a significant increase in SEC. The lowest SEC was recorded at 7.8 MJ/kg at an air velocity of 0.5 m/s and an IR intensity of 0.30 W/cm², while a maximum SEC (20.7 MJ/kg) was observed at 1.0 m/s and 0.15 W/cm². However, a significant reduction in the SEC was noticed in the combined drying system. A minimum SEC of 3.8 MJ/kg was recorded using the combined infrared-hot air convection (IR-HA) drying system, which was 91.7% and 51.7% lower than convective and IR dryers, respectively. The present study suggested a combination of IR and hot air convection at 60 °C, 0.3 W/cm² and 0.5 m/s as optimum conditions for efficient drying of biomass with a high water content.