Smart Cities leverage large networks of wirelessly connected nodes embedded with sensors and/or actuators. Cellular IoT, such as NB-IoT and 5G RedCap, is often preferred for these applications thanks to its long range, extensive coverage, and good quality of service. In these networks, wireless communication dominates power consumption, motivating research on energy-efficient yet resilient and robust wireless systems. Many IoT use cases require low latency but cannot afford high-power radios continuously operating to accomplish this. In these cases, wake-up receivers (WURs) are a promising solution: while the high-power main radio (MR) is turned off/idle, a lightweight WUR is continuously monitoring the RF channel; when it detects a wake-up sequence, the WUR will turn on the MR for subsequent communications. This article provides an overview of WUR hardware design considerations and challenges for 4G and 5G cellular IoT, summarizes the recent 3GPP activities to standardize NB-IoT and 5G wake-up signals, and presents a state-of-the-art WUR chip.
23 January 2026 in IEEE Transactions on Microwave Theory and Techniques
In this article, we present a spectrally efficient and blocker-tolerant 2.6-GHz receiver for the 5G low-power wake-up signal (LP-WUS) standard for cellular internet of things (IoT) applications. The 5G LP-WUS uses multicarrier on-off keying (OOK) (MC-OOK) modulation which enables a phase-locked loop (PLL)-less, single-phase direct conversion architecture that significantly reduces power consumption compared to a conventional cellular receiver. To achieve high sensitivity while tolerating the legacy NR traffic adjacent to the LP-WUS, the presented LP-continuous wave and control (WUR) employs a current-mode RF front-end with a current-reuse LNTA and an enhanced baseband second-order transimpedance amplifier (TIA). With a baseband (BB) Gm-C biquad filter, the LP-WUR provides fourth-order filtering in total, effectively and power efficiently suppressing the in-band (IB) blockers (adjacent NR traffic). Fabricated in 65-nm CMOS, the LP-WUR consumes 742 $\mu $ W active power and achieves a −94.5 dBm sensitivity and −63 dB out-of-band (OOB) signal-to-interference ratio (SIR).