Experimental and numerical analyses were carried out to reveal the behaviors of two-layer graded aluminum foam materials for their dynamic compaction under blast loading. Blast experiments were conducted to investigate the deformation and densification wave formation of two-layer graded foams with positive and negative gradients. The shape of the stress waveform changed during the propagation process, and the time of edge rising was extended. Finite element models of two-layer graded aluminum foam were developed using the periodic Voronoi technique. Numerical analysis was performed to simulate deformation, energy absorption, and transmitted impulse of the two-layer graded aluminum foams by the software ABAQUS/Explicit. The deformation patterns were presented to provide insights into the influences of the foam gradient on compaction wave mechanisms. Results showed that the densification wave occurred at the blast end and then gradually propagated to the distal end for the positive gradient; however, compaction waves simultaneously formed in both layers and propagated to the distal end in the same direction for the negative gradient. The energy absorption and impulse transfer were examined to capture the effect of the blast pressure and the material gradient. The greater the foam gradient, the more energy dissipated and the more impulse transmitted. The absorbed energy and transferred impulse are conflicting objectives for the blast resistance capability of aluminum foam materials with different gradient distributions. The results could help in understanding the performance and mechanisms of two-layer graded aluminum foam materials under blast loading and provide a guideline for effective design of energy-absorbing materials and structures.
The blast resistance of a sandwich-walled cylinder/ring comprising two metal face-sheets and a graded metal foam core, subjected to internal air blast loading, is investigated. Analytical models are developed for the deformation of the sandwich cylinder with positive and negative gradient cores under internal blast loading. The deformation process is divided into three distinct phases, namely the fluid–structure interaction phase, core-crushing phase, and outer face-sheet deformation phase. Finite element modeling is performed using the Voronoi material model. The proposed analytical models are verified through finite element analysis, and reasonable agreement is observed between the analytical predictions and finite element results. The sandwich structures with high energy absorption capacity or low maximum radial deflection are satisfied for the protecting purpose of impact/blast resistance requirements. Typical deformation processes are classified and analyzed; the effects of explosive charge, face-sheet thickness, and core gradient on the structural response are also examined. The results indicate that both the deformation modes and the structural response of the cylinders are sensitive to the blast charge and core configuration. It is concluded that energy absorption capacity and maximum radial deflection are two conflicting goals for achieving high impact/blast resistance capability. An in-depth understanding of the behavior in sandwich-walled cylinders under blast impulse and the influence of the core configuration helps realize the advantages and disadvantages of using graded foam materials in sandwich structures and can provide a guideline for structural design.
1 February 2016 in International Journal of Applied Mechanics
An improved expanding ring experimental technique has been described to determine dynamic material properties under conditions approximating uniform one-dimensional tensile loading. There are mainly explosive expanding ring technique and electromagnetic expanding ring technique currently, for which exist many limitations in practical applications. The work reported herein is an attempt to overcome this difficulty by lateral efficiency loading produced by projectile, made of low-density material, impacting the same material filling. The lateral efficiency loading is a convenient and effective method, which allows materials to be in uniform uniaxial stress conditions at a high stress rate. The procedure is illustrated by experiments performed on 1100-0 aluminum rings.