In the corner reflector jamming scenario, the ship target and the corner reflector array have different degrees of defocusing in the synthetic aperture radar (SAR) image due to their complex motions, which is unfavorable to the subsequent target recognition. In this manuscript, we propose an imaging method for marine targets based on time–frequency analysis with the modified Clean technique. Firstly, the motion models of the ship target and the corner reflector array are established, and the characteristics of their Doppler parameter distribution are analyzed. Then, the Chirp Rate–Quadratic Chirp Rate Distribution (CR-QCRD) algorithm is utilized to estimate the Doppler parameters. To address the challenges posed by the aggregated scattering points of the ship target and the overlapping Doppler histories of the corner reflector array, the Clean technique is modified by short-time Fourier transform (STFT) filtering and amplitude–phase distortion correction using fractional Fourier transform (FrFT) filtering. This modification aims to improve the accuracy and efficiency of extracting scattering point components. Thirdly, in response to the poor universality of the traditional Clean iterative termination condition, the kurtosis of the residual signal spectrum amplitude is adopted as the new iterative termination condition. Compared with the existing imaging methods, the proposed method can adapt to the different Doppler distribution characteristics of the ship target and the corner reflector array, thus realizing better robustness in obtaining a well-focused target image. Finally, simulation experiments verify the effectiveness of the algorithm.

Dedicated to synchronously acquiring large-area, high-precision, and multi-scale ocean wind and wave information, a novel concept of a spaceborne ocean microwave dual-function integrated sensor is proposed in this paper. It integrates the functions of a scatterometer and SAR by sharing a single phased-array antenna. An overview of the scientific requirements and motivations for the sensor are outlined firstly. In order to fulfill the observation requirements of both the functions, the constraints on the system parameters such as frequency, antenna size, and incidence angle are analyzed. Then, the selection principles of these parameters are discussed within the limitations of antenna area, bandwidth, available time, and cost. Additionally, the constraints on the time sequence of transmitting and receiving pulses are derived to ensure that there is no conflict when the two functions operate simultaneously. Subsequently, a method for jointly designing the pulse repetition frequency (PRF) of both the functions is introduced, along with zebra maps to verify its effectiveness. At the end of the paper, the system and performance parameters of the sensor are given for further insight into it.