To estimate the response of wave energy converters to different sea environments accurately is an ongoing challenge for researchers and industry, considering that there has to be a balance between guaranteeing their integrity whilst extracting the wave energy efficiently. For oscillating wave surge converters, the incident wave field is changed due to the pitching motion of the flap structure. A key component influencing this motion response is the Power Take-Off system used. Based on OpenFOAM, this paper includes the Power Take-off to establish a realistic model to simulate the operation of a three-dimensional oscillating wave surge converter by solving Reynolds Averaged Navier-Stokes equations. It examines the relationship between incident waves and the perturbed fluid field near the flap, which is of great importance when performing in arrays as neighbouring devices may influence each other. Furthermore, it investigates the influence of different control strategy systems (active and passive) in the energy extracted from regular waves related to the performance of the device. This system is estimated for each wave frequency considered and the results show the efficiency of the energy extracted from the waves is related to high amplitude pitching motions of the device in short periods of time.
This work analyzed the structural fatigue of a high-speed craft, which has a propeller system formed by two 493-hpengines connected through speed multipliers to water jet systems. Its aluminum alloy structure has combined-typeframing. The useful life of the boat bottom’s structure was determined considering the cyclical loads generatedby the propulsion system, using the Finite Elements method and applying the effort-number method of cycles tofailure. For this, a structural model was developed of the selected zone, which was analyzed with the SAP2000program, to obtain complex amplitudes of the stress supported by the structure. Thereafter, with these results thestress range was determined and, then, using S-N curves for Aluminum the number of cycles that needed to becarried out by six structural details selected was determined, for its failure. Using Miner’s Rule, combined with thecraft’s assumed work modes, the time of the useful life time of the referential details selected during an hour wasdetermined. Finally, if the craft operates for three hours per day, the bottom structure of the boat analyzed wouldhave a useful life of 14.5 years, when working principally in low speed rating.
A small craft is considered in the planing regime when its Froude number is higher than 1.2, and under that condition its weight is mainly supported by hydrodynamic pressure acting on the bottom of the hull. It is also known that installing stern flaps at a certain angle from the bottom line will alter the trim angle and, as a consequence, the resistance exerted by the water. In this work, using the classical work from Savitsky, the resistance on a planing craft is estimated, including the effect of flaps, and then the influence of those appendages on the hydrodynamic behavior of a craft of local design was experimentally verified. The wooden model was 2.0 meters long and was side towed from an outboard powered boat, with a 3.2-m arm, in a small artificial lake. The tests were run between 5 and 12 knots, with uneven intervals due to the outboard control; the model was towed without and with flaps at 5 and 10°. Finally, experimental and empirical results for towing force and trim angle were plotted. In some of the experimental curves the presence of humps may be identified, but less pronounced than with the theoretical results. Experimental resistance values are lower than those obtained from Savistky’s formulation for no flaps; in the case of flaps at 5°, the agreement in trim angle was very good. Finally, the benefit of flaps on the performance of the planing model was corroborated, but it should be emphasized that this improvement is only valid for a certain velocity range.