Huge quantities of different dyes are generated by various industries such as cosmetic, leather, printing and textile and food. This study aimed to generate and apply tire-derived activated carbon magnetised with the Fe3O4 nanoparticles (MAC) for the removal of reactive blue 19 (RB19) dye from aquatic solutions. FE-SEM, VSM, XRD, FTIR and BET analyses were used to determine MAC properties. Under optimal conditions of pH 3, the initial concentration of dye 100 mg/L, the composite dose 1 g/L and the reaction time of 45 min, the removal efficiency for RB19 was 93.22%. Isotherm findings illustrated that RB19 adsorption onto the MAC followed the Langmuir model. Moreover, the absorption kinetics is well interpreted by the pseudo-second-order model in low scrutinised concentrations. The SBET and total pure volume for the MAC were 421.11 m2 g−1 and 0.467 cm3 g−1. Under the optimum conditions, maximum adsorption capacity of the MAC in Langmuir model enhanced to the amount of 119.05 mg/g. Also, the reusability (with NaOH) of the MAC revealed about 21% decreases in the removal efficiency within five consecutive runs. It is concluded that the application of the magnetised activated carbon due to its high efficiency in removing RB19 from laboratory and actual samples can be evaluated in future studies to be utilised in real scales.
Diazinon (DZN) has been reported as an important pesticide with wide application in agriculture. The entry of these compounds into water resources has brought serious environmental problems due to their resistance to biodegradation; thus, this study was considered to be done to explore the process of DZN uptake and the influence of effective parameters. The study was performed experimentally and on a laboratory scale. Investigating the structure and morphology of the nanocomposite was done based on different analyses, i.e., FE-SEM, FTIR, and XRD. The experiments based on the Box–Behnken scheme were performed by surveying four important operating parameters (pH, contact time, nanocomposite dose, and DZN concentration). Optimization was performed by experiment design software and using the response surface method and analysis of the proposed model. The DZN removal efficiency was obtained 100% under optimal conditions including pH = 5, nanocomposite dose = 0.83 g/L, reaction time = 55 min, and DZN concentration = 5 mg/L. Considering the high correlation coefficient R2 = (0.9873) and $$R_{{{\text{Adj}}}}^{{2}}$$ = (0.9725), the proposed model (quadratic) was approved. The results were indicative of conforming the reaction kinetic to the pseudo-second-order model and the correspondence of reaction isotherm to the Freundlich model (R2 = 0.997). Based on the obtained results, the adsorption process with AC–ZnO nanocomposite could be introduced as an efficient and eco-friendly technique to remove DZN.