A cryogenic cylindrical ion trap velocity map imaging spectrometer has been developed to study photodissociation spectroscopy and dynamics of gaseous molecular ions and ionic complexes. A cylindrical ion trap made of oxygen-free copper is cryogenically cooled down to ∼7 K by using a closed cycle helium refrigerator and is coupled to a velocity map imaging (VMI) spectrometer. The cold trap is used to cool down the internal temperature of mass selected ions and to reduce the velocity spread of ions after extraction from the trap. For CO2+ ions, a rotational temperature of ∼12 K is estimated from the recorded [1 + 1] two-photon dissociation spectrum, and populations in spin-orbit excited X2Πg,1/2 and vibrationally excited states of CO2+ are found to be non-detectable, indicating an efficient internal cooling of the trapped ions. Based on the time-of-flight peak profile and the image of N3+, the velocity spread of the ions extracted from the trap, both radially and axially, is interpreted as approximately ±25 m/s. An experimental image of fragmented Ar+ from 307 nm photodissociation of Ar2+ shows that, benefitting from the well-confined velocity spread of the cold Ar2+ ions, a VMI resolution of Δv/v ∼ 2.2% has been obtained. The current instrument resolution is mainly limited by the residual radial speed spread of the parent ions after extraction from the trap.
In this work, the threshold photoionization cross sections from the excited states of lutetium and ytterbium atoms were investigated by the laser pump–probe scheme under the condition of saturated resonant excitation. We obtained the resonance enhanced multiphoton ionization spectra of the lutetium and ytterbium atoms of the lanthanide metals in the range of 307.50–312.50 nm and 265.00–269.00 nm, respectively; the photoionization cross sections of the 5d6s(1D)6p(2D05/2) and 5d6s(3D)6p(2P01/2) states of lutetium and the 4f13(2F0)5d6s2(J = 1) states of ytterbium above threshold regions (0.4–1.6 eV) were measured, and measured values ranged from 2.3 ± 0.2 to 17.7 ± 1.5 Mb.
20 April 2021 in The Journal of Physical Chemistry Letters
The photodissociation and photoionization of O2 and the subsequent photodissociation of O2+ in the wavelength region of 200 to 240 nm are reported using resonance enhanced multiphoton ionization (REMPI) and velocity map imaging detection. A series of two-photon allowed Rydberg states with principle quantum number n = 3–11 converging to the ground electronic state of O2+X2Πg are used as doorway states to reach the region of superexcited states of O2 in the three-photon energy range of 15.8–18.6 eV. A detailed analysis of the kinetic energy release and anisotropy parameters of photofragments extracted from velocity map images reveals competition between neutral dissociation and autoionization and leads to the identification of different O+ formation channels. Moreover, the measurement of anisotropy parameters for each channel gives additional information on the symmetry of electronic states involved in the absorption process. Formation followed by the dissociation of vibrationally excited O2+ is the strongest channel over the full wavelength range studied. Ground and vibrationally excited O2+(X2Πg, a4Πu, A2Πu) are formed and dissociated to ionic products via one and two-photon processes. Neutral dissociation to form electronically excited atoms is important at the longer wavelengths studied and becomes noticeably less important at shorter wavelengths. These results agree with and expand on a previous study from our lab of O+ formation at a single (2 + 1) REMPI wavelength, and the results obtained in this study are found to complement our study of the electronically analogous counterpart S2, where most of the S+ ions arise from electronically excited S* atoms. The results of this study will also be of use in the pixel-to-velocity calibration of any velocity map imaging apparatus in the wide ultraviolet wavelength regions. Because O2 is a common reactant or product in many molecular dynamics studies, knowledge of its ionization/dissociation pathways at commonly used wavelengths should also be useful in avoiding signal overlap problems.