Ultraviolet (UV)photodissociation dynamics of jet-cooled n-propyl (n-C3H7) radical via the 3sRydberg state and i-propyl (i-C3H7) radical via the 3pRydberg states are studied in the photolysis wavelength region of 230–260 nm using high-nRydberg atom time-of-flight and resonance enhanced multiphoton ionization techniques. The H-atom photofragment yield spectra of the n-propyl and i-propyl radicals are broad and in good agreement with the UVabsorption spectra. The H + propene product translational energy distributions, P(ET)’s, of both n-propyl and i-propyl are bimodal, with a slow component peaking around 5-6 kcal/mol and a fast one peaking at ∼50 kcal/mol (n-propyl) and ∼45 kcal/mol (i-propyl). The fraction of the average translational energy in the total excess energy, 〈fT〉, is 0.3 for n-propyl and 0.2 for i-propyl, respectively. The H-atom product angular distributions of the slow components of n-propyl and i-propyl are isotropic, while that of the fast component of n-propyl is anisotropic (with an anisotropy parameter ∼0.8) and that of i-propyl is nearly isotropic. Site-selective loss of the β hydrogen atom is confirmed using the partially deuterated CH3CH2CD2 and CH3CDCH3 radicals. The bimodal translational energy and angular distributions indicate two dissociation pathways to the H + propene products in the n-propyl and i-propyl radicals: (i) a unimolecular dissociation pathway from the hot ground-state propyl after internal conversion from the 3s and 3pRydberg states and (ii) a direct, prompt dissociation pathway coupling the Rydberg excited states to a repulsive part of the ground-state surface, presumably via a conical intersection.
In this work, the threshold photoionization cross sections from the excited states of lutetium and ytterbium atoms were investigated by the laser pump–probe scheme under the condition of saturated resonant excitation. We obtained the resonance enhanced multiphoton ionization spectra of the lutetium and ytterbium atoms of the lanthanide metals in the range of 307.50–312.50 nm and 265.00–269.00 nm, respectively; the photoionization cross sections of the 5d6s(1D)6p(2D05/2) and 5d6s(3D)6p(2P01/2) states of lutetium and the 4f13(2F0)5d6s2(J = 1) states of ytterbium above threshold regions (0.4–1.6 eV) were measured, and measured values ranged from 2.3 ± 0.2 to 17.7 ± 1.5 Mb.
Compared to single ion/electron-optics for velocity-map imaging, a double-focusing lens assembly designed not only allows for mapping velocity imaging of photoelectrons but also allows for investigating the vibrational structure of the intermediate states of neutral species in resonance enhanced multiphoton ionization (REMPI) spectra. In this presentation, in order to record REMPI and photoelectron spectra separately, we have constructed a compact photoelectron velocity-map imaging (VMI) apparatus combined with an opposite linear Wiley-Mclaren time-of-flight mass spectrometer (TOFMS). A mass resolution (m/Δm) of ∼1300 for TOFMS and electron energy resolution (ΔE/E) of 2.4% for VMI have been achieved upon three-photon ionization of Xe atom at 258.00 nm laser wavelength. As a benchmark, in combination of one-color (1 + 1) REMPI and photoelectron imaging of benzene via 61 and 6111 vibronic levels in the S1 state, the vibrational structures of the cation and photoelectron angular anisotropy are unraveled. In addition, two-color (1 + 1′) REMPI and photoelectron imaging of aniline was used to complete the accurate measurement of ionization potential (62 271 ± 3 cm−1). The results suggest that the apparatus is a powerful tool for studying photoionization dynamics in the photoelectron imaging using vibrational-state selected excitation to the intermediate states of neutrals based on REMPI technique.
Hydrogen production from ethanol reforming using microwave plasmas has great potential. In this study, a microwave plasma torch is used as a plasma source. Air is used as a discharge gas to generate the plasma. Ethanol and air are mixed and injected directly into the plasma reaction zone in a vortex flow. The effects of the oxygen-to-ethanol molar ratio (O2/Et), ethanol flow rate, and absorbed microwave power on the reforming results are investigated. When the O2/Et exceeds 0.9, ethanol is completely converted. The hydrogen selectivity is the largest when the O2/Et is 1.1, which is about 66.5%. The maximum hydrogen production rate is 2.19 mol(H2)/mol(C2H5OH). The best carrier gas residence time is 0.64–0.81 s. An appropriate increase in the ethanol flow rate can improve the ethanol conversion rate and energy efficiency while reducing the hydrogen selectivity and hydrogen yield, so the ethanol flow rate should not exceed 42.1 mL/min. The cost of hydrogen production is minimum [$3.66/kg(H2)] when the ethanol flow rate is 42.1 mL/min. The positive effect of the absorbed microwave power on the reforming reaction is significant, but too much microwave power also reduces energy efficiency. The optimum experimental conditions are an O2/Et of 0.9, an ethanol flow rate of 42.1 mL/min, and an absorbed microwave power of 700 W. The maximum energy yield is 861.91 NL(H2)/kWh at an absorbed microwave power of 700 W. The main reforming products are H2, CO, CO2, CH4, C2H2, C2H4, C2H6, C3H6, C3H8, C4H10n, and C4H10i. The content of C2 or higher hydrocarbons is considerably low. Almost no deposited carbon is generated in the experiment, which means that the design of the reforming system is effective in suppressing carbon deposition.