Felipe Rebelo Lopes

Dr. Felipe Rebelo Lopes

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 June 2023 in Mechanical Systems and Signal Processing
Verified
Journal Article
Closed access
DSDaniel H. Braz de Sousa
Daniel H. Braz de Sousa
FLFelipe Rebelo Lopes
Felipe Rebelo Lopes
ALAntonio W.C. Do Lago
Antonio W.C. Do Lago
MMMarco A. Meggiolaro
Marco A. Meggiolaro
HAHelon Vicente Hultmann Ayala
Helon Vicente Hultmann Ayala

27 July 2018 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
Verified
Journal Article
Closed access
PDF file
FLFelipe Rebelo Lopes
Felipe Rebelo Lopes
JGJorge Audrin Morgado de Gois
Jorge Audrin Morgado de Gois

22 January 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
MTMaria Clara Carvalho Teixeira
Maria Clara Carvalho Teixeira
MPMarcos Venicius Pereira
Marcos Venicius Pereira
Rodrigo F. M. SouzaRodrigo F. M. Souza
Rodrigo F. M. Souza
FLFelipe Rebelo Lopes
Felipe Rebelo Lopes
TSTalita Silva
Talita Silva
An experimental study was conducted to analyze temperature evolution during very high cycle fatigue tests. The temperature–number of cycles (T–N) curve is typically divided into three phases: Phase I—a rapid temperature increases at the start of the test, Phase II—temperature stabilization, and Phase III—a sharp temperature rise at the test’s end, coinciding with specimen fracture. The high frequencies used in ultrasonic fatigue testing can induce self-heating in specimens, but the thermal effects are not yet fully understood. Temperature is known to influence the fatigue performance of materials. To explore this, specimens were subjected to varying stress levels and intermittent loading conditions while monitoring temperature evolution using infrared thermography. The T–N curves were obtained, and S–N curves were constructed for specimens tested at room temperature. All tests were performed under fully reversed loading conditions. The experimental data were used to evaluate models commonly applied in conventional fatigue testing. Additionally, the temperature gradient at the beginning of the ultrasonic fatigue test and the heat dissipation per cycle were estimated and analyzed as potential fatigue damage parameters. These findings indicate that parameters derived from the T–N curve have significant potential for predicting very high cycle fatigue life.

7 December 2020
Verified
Conference Paper
Open access
FLFelipe Rebelo Lopes
Felipe Rebelo Lopes
MMMarco A. Meggiolaro
Marco A. Meggiolaro
A new generation of robots that work in cooperation with humans (called collaborative robots) needs some flexibility to adapt to the environment and activities with people. That is why the Series Elastic Actuator (SEA) has been a breakthrough in actuator technologies. The idea of inserting an elastic element in series with a motor allows a lower output impedance, consequently a flexible behavior in the manipulator, in addition to providing torque feedback to better compensate disturbances caused e.g. by friction losses. This article presents a four-bar mechanism with SEA for the purpose of robotic manipulation. Its kinematics and dynamicsare studied, as well as its regulation and trajectory control. The behavior of the decoupled four-bar mechanism and the characteristics of the SEA are also analyzed. Then the regulation control of the complete system is carried out using LQR control. Finally, a circular trajectory is controlled in a simulation to validate the proposed control strategy. The simulation results show the effectiveness of the proposed controller for the mechanism in the presence of SEAs estimating torque and providing the desired compliance for human interaction.