We report solutions for stable compound solitons in a three-dimensional quasi-phase-matched photonic crystal with the quadratic () nonlinearity. The photonic crystal is introduced with a checkerboard structure, which can be realized by means of the available technology. The solitons are built as four-peak vortex modes of two types, rhombuses and squares (intersite- and onsite-centered self-trapped states, respectively). Their stability areas are identified in the system’s parametric space (rhombuses occupy an essentially broader stability domain), while all bright vortex solitons are subject to strong azimuthal instability in uniform media. Possibilities for experimental realization of the solitons are outlined.
For a floating display system using a prism- or bead-type retroreflector, non-retroreflected light is the key cause of the deterioration in image resolution. In the present study, a micro aperture array was used to enhance the image resolution of aerial imaging displays based on prism and bead retroreflectors. The effects of different micro aperture parameters on the divergence angle of the retroreflector were experimentally studied, and the modulation of the point spread function of different retroreflectors was also explored in detail. The experimental results showed that by properly arranging the micro aperture array, the divergence angle of the retroreflective light could be effectively reduced. Moreover, the full width at half maximum of the point spread function of the retroreflector was effectively narrowed. Finally, after the modulation of the micro aperture array, the imaging resolution was increased by 115%–150% compared to the original resolution. The proposed micro array is low cost, easy to process, and flexible and can be applied to a retroreflector-based aerial imaging system to provide high image quality.
An illumination design problem can be transformed into an optimal mass transport problem based on ray mapping. To construct a freeform surface that best fits the normal field, an efficient numerical method is put forward in this paper. In this method, the normal vectors are constructed by two adjacent orthogonal tangent vectors at each point, and then the normal vectors are substituted into Snell’s law to obtain nonlinear equations describing the surface coordinates. Finally, the continuous and accurate freeform surface can be obtained by solving these nonlinear equations. The simulation results show that the proposed method not only provides lower relative standard deviation, but also significantly reduces the normal deviation more than the traditional one. It can be seen from the comparison results that different numerical integrations of a non-integrable normal field calculated by optimal mass transport can lead to different results, and the proposed method is more feasible than the traditional one, especially in the off-axis case. The simulation results of the illumination effect of some complex patterns also show that the freeform surface constructed by this method can restore the target pattern efficiently and control the normal vector error in a low range.
Constructing a freeform surface that accurately satisfies both integrable condition and Snell’s law under a given invariant source–target map is challenging for freeform design. Here, we propose a fixed-point iteration method to address this problem. This process involves solving a set of balanced gradient equations in the form of fixed-point iterations that are derived from equivalent integrability conditions and Snell’s law. By using the convergence theorem of fixed-point iteration, a unique solution for the balanced gradient equations exists, which is determined by the natural geometric properties of the freeform surface and is independent of the mapping. The gradient operators on the left-hand side of the equations are converted into a differential matrix form via a finite difference scheme. In one iteration, differential operations are forward-performed on the right-hand side of the equations, and the system of linear equations is solved on the left-hand side of the equation. The constructed freeform surfaces work well in both the paraxial and nonparaxial regions, and convergence in the nonparaxial region is faster than that in the paraxial region. The robustness and high efficiency of the proposed method are demonstrated with several design examples.
It is well known that bright vortex solitons are unstable in the nonlinear media due to the strong azimuthal modulation instability. To solve this problem, a quadratic () ferroelectric crystal with a special kind of helical-periodically poled structure is proposed. The proposed structure is designed by embedding topological charges into the crystal with a quasi-phase matching technique. Simulation results indicate that vortex solitons containing fundamental-frequency and second-harmonic waves can robustly propagate over a distance. Two types of vortex states are obtained: double vortices state and vortex–antivortex state. The dependence of effective area, propagation constants, and maximum light intensity on the control parameters are presented. These results provide a new solution for robust transmission of bright vortex solitons in a nonlinear media.
The formation and dynamics of full vortex gap solitons (FVGSs) is investigated in two-component Bose-Einstein condensates with spin-orbit coupling (SOC), Zeeman splitting (ZS), and competing cubic and quintic nonlinear terms, while the usual kinetic energy is neglected, assuming that it is much smaller than the SOC and ZS terms. Unlike previous SOC system with the cubic-only attractive nonlinearity, in which solely semi-vortices may be stable, with the vorticity carried by a single component, the present system supports stable FVGS states, with the vorticity present in both components (such states are called here full vortex solitons, to stress the difference from the half-vortices). They populate the bandgap in the system's linear spectrum. In the case of the cubic self-attraction and quintic repulsion, stable FVGSs with a positive effective mass exist near the top of the bandgap. On the contrary, the system with cubic self-repulsion and quintic attraction produces stable FVGSs with a negative mass near the bottom of the bandgap. Mobility and collisions of FVGSs with different topological charges are investigated too.