Under earthquake action, concrete silos can undergo damage over a vast area or may even collapse. To aid seismic design, a numerical simulation of the seismic performance of column-supported reinforced concrete silos was performed, and the performance was quantitatively described. The focus of the research was on determining the damage levels of these silos by adopting an incremental dynamic analysis. The focus of the research was on determining the damage levels of these silos by adopting an incremental dynamic analysis. Four limit states were defined for the first time so as to better determine the damage states of column-supported reinforced concrete silos in the event of earthquakes and the vulnerability analysis of the silo structures was carried out. The analysis results show that volume of the stored grain directly determined its damage behavior. The silo with a greater amount of stored grain entered the plastic state earlier, and the damage effect was more evident. Under the most dangerous working conditions, i.e., the full state of the silo, the 50-year collapse exceedance probability of the silo reaching collapse (LS4) was less than 1% of the 50-year failure risk limit defined in the US seismic design code FEMA P750. This demonstrated that a column-supported reinforced concrete silo can maintain its high anti-collapse reserve capacity under the effect of rare earthquakes.

The storage conditions of multi-floor grain warehouses change frequently during grain circulation. This paper investigates the effects of various storage conditions on the seismic performance of multi-floor grain warehouses. The numerical results indicate that the higher the storage material distribution position, the greater the damping ratio of the structural model and the more obvious the contribution of storage material movement to the damping of the structure. The intensity of earthquake action and the spatial height of the floor where the storage material is located are negatively correlated with the acceleration response of the structure. Under full-silo conditions, when the peak ground acceleration (PGA) is 0.4 g, the acceleration amplification factor at the top of the structure is 69.7% of the corresponding parameter at 0.1 g. The discontinuity in the storage space of the structure results in a torsional effect on the structure. When PGA = 0.22 g, the peak inter-story displacement angle of the first floor differs by nearly 1.7 times under different operating conditions, and the peak inter-story displacement angle of the second floor during an earthquake with PGA = 0.40 g differs by about 1.5 times under different operating conditions. The lateral pressure of the silo wall at different burial depths under earthquake action shows a highly nonlinear distribution trend, and the overpressure coefficient at the same burial depth of the warehouse wall is proportional to the PGA of the earthquake action. During 0.1 g, 0.22 g, and 0.40 g earthquakes, the maximum overpressure coefficients at the bottom of the warehouse wall on different floors are 1.13, 1.21, and 1.66, respectively.