Due to the lack of effective utilization, fly ash and red mud accumulate in large quantities and cause serious harm to the environment. In this experiment, a low-cost preparation of foamed ceramics was realized by applying the foaming agent addition method using fly ash and red mud. The results indicated that temperature and foaming agent content significantly affected the macrostructure, microstructure, crystalline phases, and properties of the foamed ceramics. Specifically, a formulation comprising 45 wt.% fly ash, 45 wt.% red mud, 10 wt.% clay, and 1 wt.% SiC (addition), sintered at 1210 °C, yielded a compressive strength of 8.2 MPa, a bulk density of 1.17 g/cm3, a water absorption rate of 32.05%, and an apparent porosity of 37.59%. The as-prepared materials demonstrate potential as cost-effective building materials, putting forward an effective approach for the high-value utilization of fly ash and red mud.
This study addresses the environmental and resource challenges posed by the growing volume of waste electric porcelain in the power industry by developing solar absorption and thermal storage integrated ceramics (SATS ceramics) from waste electric porcelain. These SATS ceramics, which feature an exceptional mullite structure, were crafted through the optimization of the sintering process. Notably, when sintered at 1400 °C with an 11 wt.% magnetite content, the resulting material boasts an optimal short-clustered, ordered, and interwoven columnar mullite structure. This structure endows the material with a remarkable flexural strength of 96.05 MPa and a specific heat capacity of up to 0.6415 J/(g* °C) at 300 °C, significantly enhancing its thermal energy storage efficiency. This research offers innovative insights into the high-value utilization of waste electric porcelain and the development of solar thermal storage materials, underscoring its significant environmental and economic advantages.
The prolonged outdoor storage of coal gangue leads to significant environmental issues, while the contamination of water by antibiotics poses a worldwide health concern. Conventional adsorbents are often hindered by their expense and fragility. Current studies on ceramsite derived from coal gangue have not successfully combined the repurposing of solid waste with the management of water pollution. This research utilized coal gangue and waste electric porcelain as primary materials, incorporating 2 wt.% calcium carbonate as a foaming agent, and produced ceramsite through a gradient-heating sintering process. The investigation thoroughly examined how sintering temperature and particle size distribution influenced the material’s performance. Findings indicated that mullite-based ceramsite, sintered at 1400 °C for 15 min, achieved an apparent porosity of 35.68% and a compressive strength of 10.03 MPa. A particle size distribution following a normal model resulted in a 7.9% removal efficiency of 20.00 mg/L tetracycline hydrochloride in just 30 min, with a minimal post-adsorption strength decrease of 3.7%. This study offers a theoretical framework and practical guidance for the effective utilization of coal gangue and the economical treatment of antibiotic-laden wastewater.