Yixian Yang

Ms. Yixian Yang


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 December 2022 in Processes
Verified
Journal Article
Open access
PDF file
ZLZhenfei Lv
Zhenfei Lv
XSXiulin Shen
Xiulin Shen
JGJinxuan Guo
Jinxuan Guo
YCYukun Cao
Yukun Cao
CLChong Lan
Chong Lan
JQJunyi Qi
Junyi Qi
As giant magnetostrictive material, TbDyFe is regarded as a promising choice for magnetic sensing due to its excellent sensitivity to changes in magnetic fields. To satisfy the requirements of high sensitivity and the stability of magnetic sensors, TbDyFe thin films were successfully deposited on single-crystal diamond (SCD) substrate with a Young’s modulus over 1000 GPa and an ultra-stable performance by radio-frequency magnetron sputtering at room temperature. The sputtering power and deposition time effects of TbDyFe thin films on phase composition, microstructure, and magnetic properties were investigated. Amorphous TbDyFe thin films were achieved under various conditions of sputtering power and deposition time. TbDyFe films appeared as an obvious boundary to SCD substrate as sputtering power exceeded 100 W and deposition time exceeded 2 h, and the thickness of the films was basically linear with the sputtering power and deposition time based on a scanning electron microscope (SEM). The film roughness ranged from 0.15 nm to 0.35 nm, which was measured by an atomic force microscope (AFM). The TbDyFe film prepared under a sputtering power of 100 W and a deposition time of 3 h possessed the coercivity of 48 Oe and a remanence ratio of 0.53, with a giant magnetostriction and Young’s modulus effect, suggesting attractive magnetic sensitivity. The realization of TbDyFe/SCD magnetic material demonstrates a foreseeable potential in the application of high-performance sensors.

13 February 2025 in Crystals
Verified
Journal Article
Open access
PDF file
JWJunchi Weng
Junchi Weng
XSXiulin Shen
Xiulin Shen
YYYixian Yang
Yixian Yang
XZXuejia Zhang
Xuejia Zhang
MFMengke Fan
Mengke Fan
XFXiujuan Feng
Xiujuan Feng
Due to the lack of effective utilization, fly ash and red mud accumulate in large quantities and cause serious harm to the environment. In this experiment, a low-cost preparation of foamed ceramics was realized by applying the foaming agent addition method using fly ash and red mud. The results indicated that temperature and foaming agent content significantly affected the macrostructure, microstructure, crystalline phases, and properties of the foamed ceramics. Specifically, a formulation comprising 45 wt.% fly ash, 45 wt.% red mud, 10 wt.% clay, and 1 wt.% SiC (addition), sintered at 1210 °C, yielded a compressive strength of 8.2 MPa, a bulk density of 1.17 g/cm3, a water absorption rate of 32.05%, and an apparent porosity of 37.59%. The as-prepared materials demonstrate potential as cost-effective building materials, putting forward an effective approach for the high-value utilization of fly ash and red mud.