New analysis provides insight into the basis of power-law breakdown (PLB) in the steady-state creep of metals and alloys. A variety of theories has been presented in the past but this new examination suggests that there is evidence that a dramatic supersaturation of vacancies leading to very high diffusion rates and enhanced dislocation climb is associated with the rate-controlling process for creep in PLB. The effect of vacancy supersaturation may be enhanced by dislocation short circuit diffusion paths at lower temperatures due to the dramatic increase in dislocation density.
Additive manufacturing of alloys has gained attention by industry as it provides economical production of complex-configuration engine parts with fewer joining steps and greater geometric freedom. The creep behaviour of additively manufactured (AM) Inconel 625 and 718 at 650 and 800 °C was compared with that of the wrought alloy after 24 hour and long-term tests up to about one year. Inconel 718 is precipitation strengthened while 625 is solid-solution strengthened. It was discovered that the creep strength of the 625 and 718 produced by additively manufacturing is essentially identical than that of the wrought alloy. Complications occur, however, with a marked loss of ductility in the AM alloys. Fatigue and impact toughness were adversely affected as well. The basis for these degradations was particularly investigated.