Xia Xia

Dr. Xia Xia


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 April 2020 in Molecules
Verified
Journal Article
Open access
PDF file
WDWei Dong
Wei Dong
LMLingqiang Meng
Lingqiang Meng
XHXiaodong Hong
Xiaodong Hong
SLSizhe Liu
Sizhe Liu
DSDing Shen
Ding Shen
SYShaobin 中国大陆 Yang
Shaobin 中国大陆 Yang
Lithium-sulfur batteries are very promising next-generation energy storage batteries due to their high theoretical specific capacity. However, the shuttle effect of lithium-sulfur batteries is one of the important bottlenecks that limits its rapid development. Herein, physical and chemical dual adsorption of lithium polysulfides are achieved by designing a novel framework structure consisting of MnO2, reduced graphene oxide (rGO), and carbon nanotubes (CNTs). The framework-structure composite of MnO2/rGO/CNTs is prepared by a simple hydrothermal method. The framework exhibits a uniform and abundant mesoporous structure (concentrating in ~12 nm). MnO2 is an α phase structure and the α-MnO2 also has a significant effect on the adsorption of lithium polysulfides. The rGO and CNTs provide a good physical adsorption interaction and good electronic conductivity for the dissolved polysulfides. As a result, the MnO2/rGO/CNTs/S cathode delivered a high initial capacity of 1201 mAh g−1 at 0.2 C. The average capacities were 916 mAh g−1, 736 mAh g−1, and 547 mAh g−1 at the current densities of 0.5 C, 1 C, and 2 C, respectively. In addition, when tested at 0.5 C, the MnO2/rGO/CNTs/S exhibited a high initial capacity of 1010 mAh g−1 and achieved 780 mAh g−1 after 200 cycles, with a low capacity decay rate of 0.11% per cycle. This framework-structure composite provides a simple way to improve the electrochemical performance of Li-S batteries.

28 January 2025 in Nanomaterials
Verified
Journal Article
Open access
PDF file
WXWei Xiao
Wei Xiao
XXXia Xia
Xia Xia
SWShuang Wei
Shuang Wei
YCYuehui Chen
Yuehui Chen
SYShaobin 中国大陆 Yang
Shaobin 中国大陆 Yang
A rapid increase in natural gas consumption has resulted in a shortage of conventional natural gas resources, while an increasing concentration of CH4 in the atmosphere has intensified the greenhouse effect. The exploration and utilization of coalbed methane (CBM) resources not only has the potential to fill the gap in natural gas supply and promote the development of green energy, but could also reduce CH4 emissions into the atmosphere and alleviate global warming. However, the efficient separation of CH4 and N2 has become a significant challenge in the utilization of CBM, which has attracted significant attention from researchers in recent years. The development of efficient CH4/N2 separation technologies is crucial for enhancing the exploitation and utilization of low-concentration CBM and is of great significance for sustainable development. In this paper, we provide an overview of the current methods for CH4/N2 separation, summarizing their respective advantages and limitations. Subsequently, we focus on reviewing research advancements in adsorbents for CH4/N2 separation, including zeolites, metal–organic frameworks (MOFs), and porous carbon materials. We also analyze the relationship between the pore structure and surface properties of these adsorbents and their adsorption separation performances, and summarize the challenges and difficulties that different types of adsorbents face in their future development. In addition, we also highlight that matching the properties of adsorbents and adsorbates, controlling pore structures, and tuning surface properties on an atomic scale will significantly increase the potential of adsorbents for CH4 capture and separation from CBM.

19 February 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
CZChenxiaoyu Zhang
Chenxiaoyu Zhang
SYShaobin Yang
Shaobin Yang
XZXu Zhang
Xu Zhang
XXXia Xia
Xia Xia
JLJiarui Li
Jiarui Li
Extended line defect (ELD) graphene is a two-dimensional (2D) topologically defective graphene with alternate octagonal and quadrilateral carbon rings as basic defective units. This paper reports on the CH4 adsorption properties of ELD graphene according to the first principles of density functional theory (DFT). The effects on the CH4 adsorption of ELD graphene when modified by a single Mn atom or two Mn atoms were investigated, respectively. An ELD-42C graphene configuration consisting of 42 C atoms was first constructed. Then, the ELD-42C graphene configuration was used as a substrate, and a Mn-ELD-42C graphene configuration was obtained by modifying it with a single Mn atom. The results showed that the most stable adsorption site for Mn atoms was above the quadrilateral carbon ring. This Mn-ELD-42C graphene configuration could only stably adsorb up to 30 CH4 molecules on each side, with an average adsorption energy of −0.867 eV/CH4 and an adsorption capacity of 46.25 wt%. Three 2Mn-ELD-42C graphene configurations were then obtained by modifying the ELD-42C graphene substrate with two Mn atoms. When the two Mn atoms were located on either side of a 2Mn-ELD-42C graphene configuration and above the two octagonal carbon rings adjacent to the same quadrilateral carbon ring, it was able to adsorb up to 40 CH4 molecules on each side, with an average adsorption energy of −0.862 eV/CH4 and a CH4 adsorption capacity of 51.09 wt%.

9 June 2024 in Molecules
Verified
Journal Article
Open access
PDF file
YCYuehui Chen
Yuehui Chen
FLFengxia Liu
Fengxia Liu
SWShuang Wei
Shuang Wei
XXXia Xia
Xia Xia
XLXiaodong Li
Xiaodong Li
SYShaobin 中国大陆 Yang
Shaobin 中国大陆 Yang
The utilization of lithium–sulfur battery is hindered by various challenges, including the “shuttle effect”, limited sulfur utilization, and the sluggish conversion kinetics of lithium polysulfides (LiPSs). In the present work, a theoretical design for the viability of graphitic carbon nitride (g-C3N4) and phosphorus-doping graphitic carbon nitride substrates (P-g-C3N4) as promising host materials in a Li-S battery was conducted utilizing first-principles calculations. The PDOS shows that when the P atom is introduced, the 2p of the N atom is affected by the 2p orbital of the P atom, which increases the energy band of phosphorus-doping substrates. The energy bands of PC and Pi are 0.12 eV and 0.20 eV, respectively. When the lithium polysulfides are adsorbed on four substrates, the overall adsorption energy of PC is 48–77% higher than that of graphitic carbon nitride, in which the charge transfer of long-chain lithium polysulfides increase by more than 1.5-fold. It is found that there are powerful Li-N bonds between lithium polysulfides and P-g-C3N4 substrates. Compared with the graphitic carbon nitride monolayer, the anchoring effect of the LiPSs@P-g-C3N4 substrate is enhanced, which is beneficial for inhibiting the shuttle of high-order lithium polysulfides. Furthermore, the catalytic performance of the P-g-C3N4 substrate is assessed in terms of the S8 reduction pathway and the decomposition of Li2S; the decomposition energy barrier of the P-g-C3N4 substrate decrease by 10% to 18%. The calculated results show that P-g-C3N4 can promote the reduction of S8 molecules and Li-S bond cleavage within Li2S, thus improving the utilization of sulfur-active substances and the ability of rapid reaction kinetics. Therefore, the P-g-C3N4 substrates are a promising high-performance lithium-sulfur battery anchoring material.

17 November 2025 in Small
Verified
Journal Article
Closed access
XXXia Xia
Xia Xia
WDWei Dong
Wei Dong
SYShaobin 中国大陆 Yang
Shaobin 中国大陆 Yang
SWShuang Wei
Shuang Wei
JLJijiang Liu
Jijiang Liu
HSHaiyu Sun
Haiyu Sun

9 March 2025 in Molecules
Verified
Journal Article
Open access
PDF file
XXXia Xia
Xia Xia
FZFengzhi Zhang
Fengzhi Zhang
SWShuo Wang
Shuo Wang
SWShuang Wei
Shuang Wei
XZXu Zhang
Xu Zhang
SYShaobin 中国大陆 Yang
Shaobin 中国大陆 Yang
The study of pore structure regulation methods has always been a central focus in enhancing the capacitance performance of porous carbon electrodes in lithium-ion capacitors (LICs). This study proposes a novel approach for the synergistic regulation of the pore structure in porous carbon using phenol-formaldehyde (PF) resin and boric acid (BA). PF and BA are initially dissolved and adsorbed onto porous carbon, followed by hydrothermal treatment and subsequent heat treatment in a N2 atmosphere to obtain the porous carbon materials. The results reveal that adding BA alone has almost no influence on the pore structure, whereas adding PF alone significantly increases the micropores. Furthermore, the simultaneous addition of PF and BA demonstrates a clear synergistic effect. The CO2 and H2O released during the PF pyrolysis contribute to the development of ultramicropores. At the same time, BA facilitates the N2 activation reaction of carbon, enlarging the small mesopores and aiding their transformation into bottlenecked structures. The resulting porous carbon demonstrates an impressive capacitance of 144 F·g−1 at 1 A·g−1 and a capacity retention of 19.44% at 20 A·g−1. This mechanism of B-catalyzed N2-enhanced mesopore formation provides a new avenue for preparing porous carbon materials. This type of porous carbon exhibits promising potential for applications in Li-S battery cathode materials and as catalyst supports.