Conventional LIG preparation mostly relies on the ablation process of a CO₂ laser on a polyimide (PI) substrate but is limited by the sensitivity of the laser parameters, which is prone to PI film deformation, non-uniformity of the process, or LIG surface breakage problems. In this study, we present a new method to fabricate superhydrophobic laser-induced graphene (SH-LIG) surfaces by immobilizing the polyimide (PI) film on the copper sheet, which enables uniform laser processing (single pass laser etching) over a wider range of microsecond laser parameters (10.5–19.5 W). Subsequently, the SH-LIG was obtained by vacuum-assisted immersion in stearic acid, resulting in a water contact angle greater than 150°, roll angle stabilized at 6°, and hydrophobic stability at a high temperature of 90 °C. Analysis by Raman spectroscopy (Raman), X-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) showed that the LIG fabricated at optimal power (19.5 W) had a more developed C sp² network (I_2D/I_G ≈ 0.5) and pore structure, which significantly improved the photothermal conversion efficiency (up to 252 °C in air and 180 °C on water). On this basis, a simple micro-driver based on SH-LIG was designed. Experiments showed that the maximum velocity of the SH-LIG boat can reach an adjustable propulsion velocity of 45.6 mm/s (related to the laser processing power and the intensity of the driving light), which is 132% higher than that of the LIG boat. This work provides insights into the preparation of high-quality LIG and their application in photothermally driven micro actuators, highlighting the synergies between structural optimization, surface engineering, and photothermal performance.

High-frequency electrotome (HFE) encompassing rapid cutting speed, effective hemostasis, and simple operation plays a critical role in the electrosurgical field. However, the blood and tissue adhesion on HFE can cause secondary tissue tearing and bleeding. Constrained by the blood and tissue adhesion of conventional HFEs during surgical procedure, aside from prolonged surgical time, secondary tissue tear and bleeding may occur. Available methods have been proposed to alleviate these problems, including additional devices, coating methods, and surface patterning. However, practical applications of existing HFEs with their high cost, low conductivity, and instability remain a challenge. To solve these challenges, we proposed a facile and eco-friendly superhydrophobic high-frequency electrotome (SH-HFE) based on surface patterning, which has blood anti-adhesion and tissue anti-adhesion. The mechanism contributing to superhydrophobicity was investigated by scanning electron microscopy, X-ray photoelectron spectroscopy, and Fourier-transform infrared spectroscopy. The blood adhesion experiments and tissue adhesion experiments were conducted to verify the effectiveness of SH-HFE with surface patterning in practical applications. Compared with conventional HFEs, blood adhesion and tissue adhesion on SH-HFE were reduced by 89.7% and 94.8%, respectively, while still maintaining excellent conductivity. The proposed SH-HFE would provide significant benefits to the electrosurgical field.