The interfacial bonding process and mechanical properties of AISI (American Iron and Steel Institute) stainless steel/Q235A carbon steel were investigated by deformation bonding, heat preservation, and tensile tests. The results reveal that the deformation temperature has a beneficial effect on the bonding rate, and that the critical temperature for the large-area bonding of stainless steel and carbon steel is approximately 700 °C. However, owing to the short contact time, only a shallow diffusion of approximately 2–3 µm can be achieved. A slight decrease in the interfacial bonding rate after heat preservation is correlated to the difference between the thermal expansion coefficients of the two materials, but the thickness of the diffusion layer shows a significant increase. It was found that the strength of the composites is mostly related to the bonding rate and the strength of the relatively soft material, which can be determined using an explicit equation. Moreover, with the increase in the interfacial bonding rate, the crack source changes from the junction of the unbonded and bonded areas of the interface to the interior of the carbon steel. The failure mode evolves from cleavage brittle fracture to ductile–brittle mixed-mode fracture, and then to ductile fracture.
The void closure mechanism during the roll-bonding process was investigated using a multiscale approach, which includes contact deformation at the macro-scale and atomic bonding at the micro-scale. The closure process of the voids was observed using roll-bonding tests of 304 stainless steel/Q235 carbon steel. A finite element model was built to simulate the macroscopic deformation process of 304/Q235 material, and a molecular dynamics model established to simulate the deformation process of the microscopic rough peaks. The closure law and mechanism of interface voids at the macro- and micro-scales were studied. The results show that the closure rate of interface voids decreases with the decrease in the average contact stress during the contact deformation process. In the atomic bonding process, the void closure rate is slow in the elastic deformation process. The ordered atoms near the interface become disordered as plastic deformation occurs, which increases the void closure rate and hinders dislocation propagation through the interface, resulting in significant strengthening effects via plastic deformation. Ultimately, a perfect lattice is reconstructed with void healing. In addition, the interface morphology after roll-bonding at the macro scale was determined by the morphology of the 304 steel with larger yield strength ratio, while the interface morphology at the micro-scale was mainly determined by the morphology of the Q235 steel with a higher yield strength.