This work presents a novel readout system for the Timepix3-based detector, designed specifically for large-scale facilities, such as particle accelerators. The authors begin by outlining the challenges associated with utilizing the Timepix3 detector over long distances. This paper proposes a solution to these challenges and describes its practical implementation. Beam test results are provided to demonstrate the system’s performance, with a particular focus on time-of-flight measurements. Additionally, the authors address the complexities of operating in challenging environments, particularly those involving radiation and magnetic fields.
6 August 2022 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
This paper describes a fast serial digital signal receiver for applications in nuclear instrumentation. The proposed design uses a Microsemi Polarfire FPGA embedded Ethernet transceiver for data oversampling (with frequency up to 12.7 GHz) and deserialization. The subsequent FPGA implemented digital signal processing chain then analyses the oversampled data array (at least 4 samples per data bit are required by the processing logic). This processing chain begins with a frame buffer, which ensures that the entire sampled data frame can be captured and a 5-bit majority parallel filter. Following start sequence detection logic uses a comparator array for valid data triggering and data offset evaluation. These information are then used by the sampling point selection logic for data restoration. Thanks to the single clock cycle operation of each of these logic blocks, the processing chain provides a constant propagation delay and no dead time is required between individual data frames. The device prototype based on this design is described and measurement results for a data bit rate of 400 MHz and a sampling rate of 3.2 GHz are presented.