The high pressure branch pipe in hydropower station (BPHS) is usually composed by different materials in different parts and has complicated geometric configurations. The accurate and efficient methods for safety evaluation of the BPHS are still desirable. By introducing the element bearing ratio (EBR), generalized yield criterion as well as the reference volume concept, the elastic modulus reduction method (EMRM) is improved and applied to determine both the upper and lower bounds on limit loads of the BPHS. The global safety factor (GSF) is defined as the ratio of limit load to design load. The safety performance of the BPHS is assessed by comparing the GSF resulted from the EMRM with its allowable value specified in code. The efficiency and precision of the proposed method for safety evaluation of the BPHS are demonstrated through numerical examples in this paper. The results show that the proposed method is more suitable for safety evaluation and design optimization of the BPHS, compared with the elastic stress analysis method (ESAM) based on stress categorization which might underestimate the safety performance of the BPHS.
This study investigates the design methods for the overall stability capacity in equal-leg angles under axial compression and those subjected to eccentric compression with single-sided connections. It compares eight current codes from China, Europe, Australia, and the United States, emphasizing the differing design considerations for equal-leg angles. The research is based on 712 sets of axial compression tests and 226 sets of eccentric compression tests with single-sided connections on equal-leg angles, examining the discrepancies between the calculated and tested overall stability capacities as per the codes. The findings indicate significant variations in calculated capacities across the eight codes, with a general inclination towards conservatism in axial compression designs for equal-leg angles. Codes such as AS 4100, AS/NZS 4600, and the general method of EN 1993-1-1 use the axial compression-bending (N–M) interaction equation for eccentric compression, whereas GB 50,017, DL/T 5154, EN 1993-3-1, and the concise method of EN 1993-1-1 use a simplified axial compression formula for eccentric compression. These simplified methods deviate from practical engineering scenarios, especially for single-sided connected eccentric compression equal-leg angles. Following a comprehensive evaluation of the codes and test results, this study suggests a revision to the stability factor in GB 50,017 for axial compression in equal-leg angles. Additionally, it introduces a new design method for the overall stability capacity of single-sided connected eccentric compression in equal-leg angles, drawing on the N–M interaction equation from AS/NZS 4600. The paper concludes with the experimental data validation of the proposed stability factor for axial compression in equal-leg angles and the new design method for eccentric compression in equal-leg angles.