This paper reports the performances of a silicon photonics optical switch matrix fabricated by using large scale 3D integration. The wavelength selective optical switch consists of a photonic integrated circuit (PIC), with 1398 circuit elements, interconnected in a 3D stack with its control electronic integrated circuit (EIC). Each PIC element can be trimmed or reconfigured by using metallic heaters. The EIC is designed to drive the heaters and to read the signal of monitor photodiodes integrated into the PIC. Small footprint and high energy efficiency are achieved in the PIC and the EIC. Automatic wavelength alignment of the optical circuits in the PIC to the ITU grid and fine temperature tuning of each photonic element to optimize the switch insertion losses are obtained by an optimization routine. A fully packaged switch with input/output fibers is tested both for optical and electrical characteristics as well as for the system performances. Fiber to fiber insertion losses of about 20 dB and channel isolation of -35 dB are achieved. BER characteristics at 25 Gbps are evaluated. Perspective applications of the optical switch in optical transport and intra-data center networks are discussed.

The evolution beyond 5G towards 6G will accelerate the transformations begun by 5G to deploy new approaches to define delivery services. The network should be accessible anywhere, always-on and with the guarantee performances. This poses new challenges to the transport network that should assure available connectivity among the functions at different levels of granularity. The transport network should be so flexible to guarantee on-demand the connectivity among the processing functions that automatically will be required and, at the same time, should assure extreme performance. Optical network and Dense Wavelength Division Multiplexing technology are relevant candidates to match high bandwidth and low latency, but new challenges are required to assure the suitable cost and size for the wireless access networks. The current optical technology, suitable used in aggregation and long-haul transport network, cannot be simply downsized to be used in the access area, but novel paradigm should be considered for the optics as well. Integrated photonics seems a promising direction to realize low cost and low size optical components for the transport network. Moreover, this technology enables a certain level of remote tunability and reconfiguration of optical equipment that allow to simplify and reduce cost of installation in field and operation of the transport network. In this paper relevant optical components for transport networks are analyzed using the integrated photonics to assess the technology challenges.

5G and its evolution towards 6G is unlocking new use cases that will require the reconsideration of the existing network architectures and its operation. As the network will be required to support new service types and radio protocol splits, the traditional physical point to point connections will need to be replaced with a transport network up to the antenna site to guarantee low latency services and high bandwidth. Optical based transport is a key enabler to realize such a convergent network, where the traditional fixed infrastructure in use for mobile services and mobile infrastructure should also support enterprises services. The Software Defined Network (SDN) and Network Function Virtualization (NFV) technology plays a key role to evolve towards digitalization. It allows to simplify the creation of new services and to implement a real decoupling between the infrastructure and the network functions that run virtually, on generic processing units located everywhere in the network. Supporting automation is a key requirement that traditional optical technology is not able to meet. In this paper the reference scenarios for the access network are presented with the analysis of their requirements and the enabling optical solutions based on integrated silicon photonics.