Introduction: Transdermal patches and medicated plasters (patch) represent well-established prolonged release dosage forms. Even if satisfactory adhesion to the skin is strictly linked to the efficacy and safety of the therapeutic treatment, nowadays numerous reports of in vivo ‘adhesion lacking’ are still addressed to regulatory agencies. The adhesive properties of a patch should be characterized considering i) the ability to form a bond with the surface of another material on brief contact and under light pressure (tack); ii) the resistance of the adhesive to flow (shear adhesion); and iii) the force required to peel away a patch from a surface (peel adhesion). Areas covered: In this manuscript, the most widely used methods to measure adhesive properties during development studies are described, along with the quality control of patches. The influence of formulative variables on patch adhesive properties, and their possible relationship with the in vivo adhesion performances, is also discussed. Expert o...

Context: The selection of a proper taste-masking agent (TMA) is a critical issue in the development of fast‐dissolving films containing bitter drugs. Objective: This work is aimed to evaluate the suppression of the bitter taste of a maltodextrin fast-dissolving film loaded with 13.4 mg sodium diclofenac (DS) by adding TMAs. Methods: The films were prepared by casting and drying aqueous mixtures of maltodextrin (DE = 6), glycerin, sorbitan oleate, and DS. Films were characterized in terms of thickness, tensile properties, film disintegration time, and drug dissolution time. The bitterness intensity of DS and the masking effect of TMAs were evaluated by an electronic tongue. Results: The ‘mint’ and ‘licorice’ flavors and sucralose mixture resulted appropriate to mask DS bitterness as confirmed by a panel of volunteers. The addition of these TMAs did not significantly affect the film disintegration time (15–20 seconds) and DS dissolution rate (about 5 minutes). Conclusion: The electronic tongue was allowed to discriminate the effect of the TMA also in the presence of other hydrosoluble constituents of the film. Therefore, because of its simplicity and rapidity, this technique could assist or even replace the sensory evaluation in the development of fast‐dissolving films.