Background: As the second most abundant polysaccharide in nature, hemicellulose can be degraded to xylose as the feedstock for bioconversion to fuels and chemicals. To enhance xylose conversion, the engineered Saccharomyces cerevisiae with xylose metabolic pathway is usually adapted with xylose as the carbon source in the laboratory. However, the mechanism under the adaptation phenomena of the engineered strain is still unclear. Results: In this study, xylose-utilizing S. cerevisiae was constructed and used for the adaptation study. It was found that xylose consumption rate increased 1.24-fold in the second incubation of the yYST12 strain in synthetic complete-xylose medium compared with the first incubation. The study figured out that it was observed at the single-cell level that the stagnation time for xylose utilization was reduced after adaptation with xylose medium in the microfluidic device. Such transient memory of xylose metabolism after adaptation with xylose medium, named “xylose consumption memory”, was observed in the strains with both xylose isomerase pathway and xylose reductase and xylitol dehydrogenase pathways. In further, the proteomic acetylation of the strains before and after adaptation was investigated, and it was revealed that H4K5 was one of the most differential acetylation sites related to xylose consumption memory of engineered S. cerevisiae. We tested 8 genes encoding acetylase or deacetylase, and it was found that the knockout of the GCN5 and HPA2 encoding acetylases enhanced the xylose consumption memory. Conclusions: The behavior of xylose consumption memory in engineered S. cerevisiae can be successfully induced with xylose in the adaptation. H4K5Ac and two genes of GCN5 and HPA2 are related to xylose consumption memory of engineered S. cerevisiae during adaptation. This study provides valuable insights into the xylose adaptation of engineered S. cerevisiae.
Microfluidics has significantly advanced the field of single-cell analysis, particularly in studies related to cell growth, division, and heterogeneity. Electrical impedance spectroscopy (EIS), a label-free and non-invasive biosensing technique, has been integrated into microfluidic devices for high-throughput and long-term monitoring of single budding yeast cells. Accurate interpretation of EIS measurements of cell growth dynamics necessitates the establishment of theoretical equivalent circuit models for the single-cell sensing system. Here, we report on the development of equivalent circuit models of an in situ EIS sensing system to elucidate cell growth. Firstly, finite element modeling and simulation of an EIS measurement of cell growth in the EIS sensing unit were performed, guiding the fittings of electrical components for an established equivalent circuit model (ECM). From the ECM, we extracted an equivalent volume fraction applicable to various cell and sensing unit geometries to describe the geometry-dependent sensing characteristics corresponding to the electrical response in the model. Then, EIS measurements of an immobilized cell in a microfluidic device were conducted via peripheral circuits. A lumped parameter model for the entire EIS measurement system was established, with electrical components determined by fitting to experimental data. The rationality of the proposed theoretical model was validated through the long-term impedance variation induced by cell growth in experiments, demonstrating its feasibility in linking EIS data with the bio-physics underlying the experimental phenomenon.