This study aims to establish an equivalent parallel capacitance model for a copper/polydimethylsiloxane (Cu/PDMS) capacitive flexible pressure sensor and modulate its relative permittivity to optimize pressure sensing performance. The Cu/PDMS composite material is an ideal dielectric layer for sensors due to its high dielectric constant and tunable elasticity. By adjusting the different mixing ratios of PDMS and copper particles in micro size, the components and structure properties of the composite material can be modified, thereby affecting the electrical and mechanical performance of the sensor. We used finite element analysis (FEA) to model the sensor structure and studied the capacitance changes under various normal loading conditions to assess its sensitivity and distribution characteristics. Experimental results show that the sensor has good sensitivity and repeatability in the pressure range of 0 to 50 kPa. Additionally, we explored the effect of the addition of carbon black particles. It could be inferred that the added carbon black can enhance electrical properties due to its conductivity, which would be consequenced by the distribution optimization of Cu particles for carbon black’s low density, and it can mechanically restore some flexibility up to nearly 20%. Through these studies, our work can provide theoretical support for the design and application of flexible pressure sensors.
Achieving precise microstructure control in composite dielectric layers remains a key challenge for enhancing the sensitivity and reducing the power consumption of flexible capacitive sensors. In this work, an ultrasonic needle-induced acoustic streaming strategy is proposed to regulate the spatial distribution of Fe particles within a silicone matrix, enabling controllable particle migration and aggregation in liquid silicone. Multiphysics simulations reveal that, at an excitation frequency of 75.49 kHz, Fe particles are effectively driven toward the ultrasonic focal region, forming a tunable microstructure. Experimental results confirm that this method enables precise morphological control of the composite dielectric layer. The composite with 25 wt% Fe exhibits the highest measured relative permittivity of about 3.45, enabling a capacitive sensor sensitivity of 0.423 kPa−1 in the 0–1 kPa range. After acoustic-streaming optimization and integration into a four-unit capacitive array, the device achieved 0.509 kPa−1 sensitivity, retained 92.04% of its response after 5000 cycles at 3 kPa, and maintained 97.8% of its initial capacitance after 24 h. The proposed approach provides an effective route to improving sensor performance through microstructure engineering while maintaining low electrical loss. This work not only advances the design of high-performance functional composites but also expands the application of acoustic streaming techniques in low-power flexible electronics.