Friction Stir Processing (FSP) is a technology in which the microstructure of a material, as well as the mechanical properties of this material, is enhanced by the action of friction with a special tool. There are many applications for FSP materials which are in high demand in various industries, including aerospace, shipbuilding, instrumentation, and many others. The paper presents a study of a hybrid composite made from silicon carbide powder and rice husk (RHP) as reinforcement, included in the Al6082 aluminum alloy. The study of the characteristics of the fabricated composite was performed using an optical microscope, field emission scanning electron microscope (FESEM), X-ray diffraction (XRD) method. Tensile strength (UTS) and hardness were determined. It was revealed by microscopy that a modification of the microstructure occurs on the surface of the composite. X-ray diffraction analysis showed the presence in the spectrum of elements similar to the Al/SiC/RHP hybrid composition. It is shown that UTS tensile strength and Brinell hardness is being increased by factors of 1.36 and 1.75, respectively, compared to base aluminum material.
16 October 2022 in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
Nowadays, a lot of animal waste is available in the world. To reduce the number of animal waste particles, it is used as reinforcement, reducing the cost of reinforcement without affecting the present qualities. In this research, AA6061 is used because of its lower weight-to-strength ratio whereas to reduce the cost of reinforcement, chicken bone powder (CBP) with varying percentages (2%, 4%, and 6%) and 2% SiC is used. A hexagonal tool with a scroll shoulder is used for the fabrication of AA6061/SiC/CBP hybrid composite. Microstructural analysis, scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), fractography analysis, tool analysis, tensile strength, and hardness are used for the analysis of AA6061/SiC/CBP hybrid composite. Microstructural analysis shows that the grain size of SiC and CBP particles is reduced from 40 to 4.6 μm. Homogenous distribution of the reinforcement with no agglomeration is observed in SEM analysis. Fractography shows the presence of dimples and micro-dimples which indicates that tensile strength increases whereas XRD analysis investigates that there are no unwanted contaminants present in the AA6061/SiC/CBP hybrid composite which can be harmful during machining. Tensile strength and hardness of AA6061/SiC/CBP hybrid composite increase up to 29.28% and 18.22%, respectively, on increasing the percentage of chicken bone powder in reinforcement.
A hybrid aluminum composite obtained with friction stir processing was investigated in this study. AA6082-T6 was reinforced with particles of SiC and chicken bone powder (CBP). The weight fraction of SiC was constant (5 weight percentage) and for chicken bone powder (4 weight percentage). There were three tool profiles used in this study that are square, taper, and hexagonal. Scroll shoulder profiles are included in these tool profiles. With the aid of an optical microscope and a field effect scanning electron microscope, the morphology of the final composite and particle dispersion was studied. Hardness, tensile strength, and elongation are three mechanical qualities that alter the hybrid composite that is created due to variations in the tool’s rpm, tilt angle, and profile. The resultant hybrid composite underwent XRD analysis to ascertain its crystallographic structure. This study concludes that tensile strength increases when the hexagonal tool profile is used at 1500 rpm. As hexagonal has six edges which helped attain the required heat to soften the material and obtain a homogeneous structure with negligible defects. The mechanical properties of the obtained hybrid composite showed improvement as compared to base material AA6082-T6.