The subject matter of this study is algorithms for measuring the components of an aircraft speed vector and altitude. The goal of this study is to improve algorithms for processing wideband stochastic pulse signals in helicopter low-altitude and flight-speed radio systems by introducing secondary signal processing based on artificial intelligence elements. The tasks to be solved are as follows: to develop an optimal algorithm for determining the speed and altitude of flight for a helicopter radio complex; to supplement the signal processing algorithm with an artificial intelligence-based processor to determine the "safety" of the current trajectory; provide the pilot with relevant information about possible options for further actions based on an analysis of the current position of the helicopter and flight parameters; and to analyse the efficiency of the proposed complex when using various artificial intelligence-based algorithms. The methods used are as follows: methods of mathematical statistics and optimal solutions for solving problems of statistical synthesis of active radio complex structure; methods of machine learning; and methods of computer simulation. The following results were obtained. The algorithms for signal processing in a helicopter radio complex are obtained by the method of maximum likelihood, and the use of three radio channels to calculate the full vector of speed and altitude is argued. The structure of a secondary information processing system, using algorithms based on artificial intelligence is proposed. The effectiveness of determining the safety of the current landing trajectory using various algorithms based on artificial intelligence (LinearSVC, GaussianNB, DecisionTreeClassifier, RandomForestClassifier, KNeighborsClassifier, MLPClassifier and RidgeClassifier) was analysed. Conclusions. The simulation results show that in the presence of accurate (noise-free) information on the current location of the helicopter, its axial velocities, and a map of the terrain with defined areas dangerous for landing, the DecisionTreeClassifier and RandomForestClassifier algorithms can provide a high probability of correctly determining the safety of the current landing trajectory. At the same time, in the presence of instability in the measurements of helicopter movement parameters, only the RandomForestClassifier algorithm maintains high accuracy.
28 August 2024 in RADIOELECTRONIC AND COMPUTER SYSTEMS
The subject of this article is the design of a cheap, simple, and highly accurate on-board radar system for determining the angular position of radio-signal emission stations, which can be used to guide UAVs to a specified area of space. The aim of this study is to develop high-precision functioning algorithms, practical recommendations for implementation, and experimental measurements of the main parameters of the onboard radio direction finders of radio radiation sources placed on winged UAVs. Objectives of the research: 1) analysis of the statistical theory of optimization of signal processing algorithms in radar systems; 2) synthesis of direction-finding algorithms for radio measurement sources capable of performing measurements with high accuracy and in a wide range of unambiguous measurement angles; 3) synthesis of the radio direction finder structural scheme and its simulation modelling; 4) design of radio direction finder receiving antennas capable of operating separately and in a complex; 5) justification of the choice of components for the input paths of receivers, parameters of ADC and microcomputers that make up the main components of the radar complex; 6) manufacturing of a working model of the radar complex; 7) experimental measurements in the laboratory. The methods for solving the tasks are based on the statistical theory of optimization of radio engineering systems for remote sensing and radar, existing software tools for simulation modelling, and the theory of radio measurements. The main idea behind creating a cheap, simple, and highly accurate on-board radar system for radio emitter direction finding is to combine the results of angular position measurements from several amplitude and phase meters. This approach allows us to create an easy-to-implement radio system with the advantages of different measuring instruments. The following results were obtained: 1) theoretical studies and simulation modelling confirmed that by combining measurements from a two-antenna amplitude direction finder with narrow diagrams, a two-antenna direction finder with wide diagrams, and a two-antenna phase finder, it is possible to achieve both high accuracy and a wide range of unambiguous measurements; 2) a radar system based on a cheap and commonly available element base was developed; 3) antennas were developed that can be easily installed under the wings of UAVs; 4) experimental studies confirmed the performance of complex signal processing in an on-board six-antenna radio direction finder. The material of this work forms the basis for further experimental development of radio-direction finders for various purposes, opens up opportunities for overcoming the contradiction between accuracy and range of unambiguous measurements, and highlights an additional direction for increasing the autonomy of winged UAVs.
The main advantages of helicopters include the ability to reduce the altitude and flight speed, hovering in the air, unscheduled landing and low sensitivity to weather conditions. These advantages over airplanes make it possible to use helicopters for a variety of tasks. At the same time, there remains an unresolved problem of helicopter landing on unequipped sites with unknown terrain in poor weather conditions, low visibility, at night and in smoke-filled areas. To solve this problem, a theoretical study of the optimal algorithm for the formation of the surface relief by an airborne helicopter radar was carried out. The obtained analytical expressions are analyzed and the structural diagram of the airborne sum-and-difference system for measuring the range and angular position of scattered radar pulses is proposed. The obtained results are confirmed by simulation modeling.
The main advantages of helicopters include the ability to reduce altitude and flight speed, hover in the air, unscheduled landings, and low sensitivity to weather conditions. These advantages over the aircraft allow the use of helicopters for civilian and military purposes. Simultaneously, the problem of landing the helicopter on an unequipped area with unknown terrain in bad weather conditions, in low visibility, at night, and in smoky areas remains unsolved. This research optimizes the algorithm of terrain formation from a helicopter. To achieve this goal, the radio wave range is used, which allows to operate the system regardless of external conditions and lighting. The geometry of the problem assumes that the distance to each point of the surface is measured by the pulse method. In the bow of the helicopter, there are two antennas, which due to the spatial diversity form two patterns that overlap some areas of the underlying surface. The summary and differential channels are formed from the antenna outputs. During the formation of the input data, mathematical models of the probing signal and the received observations are given, considering the influence of the atmosphere on the propagation of waves and the internal noise of the system. A theoretical study of the optimal algorithm for forming the surface relief by on-board helicopter radar was performed within the method of maximum likelihood. The obtained analytical expressions help calculate the angular position of the pulse volume, which can then be used in the formation of the surface of the area to be landed. Because of the analysis, a structural scheme of the onboard sum-difference system of measurement of range and the angular position of the scattered radar pulses is proposed. The block diagram clarifies the principle of operation of the optimal algorithm and implements the construction of relief. In accordance with the developed algorithm, a simulation was performed, which resulted in angular positions in degrees. The obtained initial data prove the efficiency of the presented on-board radar for the formation of the underlying surface.
The study is dedicated to the statistical optimization of radar imaging of surfaces with the synthetic aperture radar (SAR) technique, assuming a static surface area and applying the ability to move a sensor along a nonlinear trajectory via developing a new method and validating its operability for remote sensing and non-destructive testing. The developed models address the sensing geometry for signals reflected from a surface along with the observation signal–noise equation, including correlation properties. Moreover, the optimal procedures for coherent radar imaging of surfaces with the static SAR technology are synthesized according to the maximum likelihood estimation (MLE). The features of the synthesized algorithm are the decoherence of the received oscillations, the matched filtering of the received signals, and the possibility of using continuous signal coherence. Furthermore, the developed optimal and quasi-optimal algorithms derived from the proposed MLE have been investigated. The novel framework for radio imaging has demonstrated good overall operability and efficiency during simulation modeling (using the MATLAB environment) for real sensing scenes. The developed algorithms of spatio–temporal signal processing in systems with a synthesized antenna with nonlinear carrier trajectories open a promising direction for creating new methods of high-precision radio imaging from UAVs and helicopters.