Standardization is a key element in the effective use of lean manufacturing methodologies and tools for achieving process sustainability. Their combination is conducive to eliminating waste and improving the efficiency of production processes and guarantees the company that employees use the most efficient tools and do not waste time on unnecessary activities. These activities can be further improved by using digital solutions, in accordance with the concept of Industry 4.0. Therefore, the authors have developed the e-Lean system, whose task is to digitize selected lean manufacturing tools. The subject of this work is analysis of the functionality and effectiveness of the essential part of the e-Lean system in the form of specialized TPM (Total Productive Maintenance) software as an application. During implementation in a construction production company, the TPM application was tested by lean manufacturing and maintenance specialists. The research consisted of assessing the functionality and efficiency of processes in relation to conventional TPM solutions. Additional functionalities of the e-Lean system have been confirmed, such as systemic approval of machinery inspection, which requires passing all necessary steps at individual inspection points, direct access for supervisors to the results of inspection activities and their status, direct and easy access to photographic documentation of machines added during inspection both in optimization of working time and its course (e.g., the optimal number of steps taken by the employee during the inspection), as well as an efficient system of motivating employees (collecting points). The improvement in the effectiveness of processes was determined by measuring the control times for three control points (polymerization furnace, packing area, and defibering machines). The average control time was reduced from 16,200 to 13,923 s. Thus, thanks to the use of the application, it was found that the efficiency of using the TPM tool was increased by approx. 15% compared to previously used non-digital solutions.

The study presents a practical application of multi-criteria standardization of machines and devices in the design of the automated production processes in industry 4.0 and its direct impact on the economic aspects of an enterprise, along with a comparison of the state before and after the implementation of the proposed changes. The solutions recommended in the article also fit into the assumptions of low-carbon development by implementing solutions that reduce energy consumption. The research carried out and presented in the text confirmed the effectiveness of the described solution. The study also presents examples confirming the correctness of implementing standardization, synergy and coherence in the design of production processes. Additionally, a new advanced eLean application was presented to support production processes in the field of Lean Management. The Total Productive Maintenance (TPM) module currently implemented in the industry is concerned with ensuring the maximum efficiency of machines and devices.

Results of a study on influence of Cr, Mo and Al on the microstructure, abrasive wear and corrosion resistance of Ni-Mn-Cu cast iron in the as-cast and heat-treated conditions are presented. Because of the chilling effect of first two elements (tendency to create hard spots), graphitising Al was added to the alloys, with the highest concentration of Cr and Mo. All castings in the as-cast condition showed an austenitic matrix, guaranteeing good machinability. Heat treatment of raw castings, consisting in annealing at 500 °C for 4 h, resulted in partial transformation of austenite. As a result the carbon-supersaturated acicular ferrite, morphologically similar to bainitic ferrite was formed. The degree of this transformation increased with increasing concentrations of Cr and Mo, which successively decreased the thermodynamic stability of austenite. A change of matrix structure made it possible to significantly increase hardness and abrasive-wear resistance of castings. The largest increment of hardness and abrasion resistance was demonstrated by the castings with the highest total concentration of Cr and Mo with an addition of 0.4% Al. Introduction of Cr and Mo also resulted in an increase of corrosion resistance. In the heat-treated specimens, increasing the concentration of Cr and Mo resulted in a successive decrease of the depth of corrosion pits, with an increase in their number at the same time. This is very favourable from the viewpoint of corrosion resistance.